This patch series draft should adds support for Freescale i.MX23, i.MX28 on-chip regulators. I'm new to regulator drivers and need early feedback for the driver's stage before i go in the wrong direction. The information about the i.MX28 regulators are from chapter 11 of the reference manual [1]. This driver based on the Freescale high level [2] and low level driver [3], but contains the following changes: * devictree support * code cleanup Please bear in mind that the code is not tested against real hardware and it's not expected to work. I'm not sure if it's correct, but these series based on the for-next branch of Mark Brown's regulator repository. Any comments about the code are welcome. [1] - http://cache.freescale.com/files/dsp/doc/ref_manual/MCIMX28RM.pdf [2] - http://git.freescale.com/git/cgit.cgi/imx/linux-2.6-imx.git/tree/drivers/regulator/mxs-regulator.c?h=imx_2.6.35_maintain [3] - http://git.freescale.com/git/cgit.cgi/imx/linux-2.6-imx.git/tree/arch/arm/mach-mx28/power.c?h=imx_2.6.35_maintain Stefan Wahren (3): DT: add binding for MXS regulator ARM: regulator: add Freescale MXS regulator driver DT: ARM: mxs: enable regulator support for i.MX28 .../bindings/regulator/mxs-regulator.txt | 38 ++ arch/arm/boot/dts/imx28.dtsi | 50 ++- drivers/regulator/Kconfig | 9 + drivers/regulator/Makefile | 1 + drivers/regulator/mxs-regulator.c | 411 +++++++++++++++++++++ 5 files changed, 508 insertions(+), 1 deletion(-) create mode 100644 Documentation/devicetree/bindings/regulator/mxs-regulator.txt create mode 100644 drivers/regulator/mxs-regulator.c -- 1.8.1.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
