Add device-tree support for the MIPS GIC. With DT, no per-platform
static device interrupt mapping is supplied and instead all device
interrupts are specified through the DT. The GIC-to-CPU interrupts
must also be specified in the DT.
Platforms using DT-based probing of the GIC need only supply the
GIC_NUM_INTRS and, if necessary, MIPS_GIC_IRQ_BASE values and
call of_irq_init() with an of_device_id table including the GIC.
Currenlty only legacy and vecotred interrupt modes are supported.
Signed-off-by: Andrew Bresticker <abrestic@xxxxxxxxxxxx>
---
Changes from v1:
- updated for change in bindings
- set base address and enable bit in GCR_GIC_BASE
---
arch/mips/include/asm/gic.h | 15 ++++++
drivers/irqchip/irq-mips-gic.c | 102 ++++++++++++++++++++++++++++++++++++++++-
2 files changed, 116 insertions(+), 1 deletion(-)
diff --git a/arch/mips/include/asm/gic.h b/arch/mips/include/asm/gic.h
index 3beb4eb..3853c15 100644
--- a/arch/mips/include/asm/gic.h
+++ b/arch/mips/include/asm/gic.h
@@ -348,6 +348,10 @@ struct gic_shared_intr_map {
#define GIC_CPU_INT3 3 /* . */
#define GIC_CPU_INT4 4 /* . */
#define GIC_CPU_INT5 5 /* Core Interrupt 7 */
+#define GIC_NUM_CPU_INT 6
+
+/* Add 2 to convert GIC CPU pin to core interrupt */
+#define GIC_CPU_PIN_OFFSET 2
/* Local GIC interrupts. */
#define GIC_INT_TMR (GIC_CPU_INT5)
@@ -390,4 +394,15 @@ extern void gic_disable_interrupt(int irq_vec);
extern void gic_irq_ack(struct irq_data *d);
extern void gic_finish_irq(struct irq_data *d);
extern void gic_platform_init(int irqs, struct irq_chip *irq_controller);
+
+#ifdef CONFIG_IRQ_DOMAIN
+extern int gic_of_init(struct device_node *node, struct device_node *parent);
+#else
+static inline int gic_of_init(struct device_node *node,
+ struct device_node *parent)
+{
+ return 0;
+}
+#endif
+
#endif /* _ASM_GICREGS_H */
diff --git a/drivers/irqchip/irq-mips-gic.c b/drivers/irqchip/irq-mips-gic.c
index c0ff749..d885749 100644
--- a/drivers/irqchip/irq-mips-gic.c
+++ b/drivers/irqchip/irq-mips-gic.c
@@ -8,17 +8,23 @@
*/
#include <linux/bitmap.h>
#include <linux/init.h>
+#include <linux/of_address.h>
+#include <linux/of_irq.h>
#include <linux/smp.h>
-#include <linux/irq.h>
+#include <linux/interrupt.h>
#include <linux/clocksource.h>
#include <asm/io.h>
+#include <asm/irq_cpu.h>
#include <asm/gic.h>
#include <asm/setup.h>
+#include <asm/mips-cm.h>
#include <asm/traps.h>
#include <linux/hardirq.h>
#include <asm-generic/bitops/find.h>
+#include "irqchip.h"
+
unsigned int gic_frequency;
unsigned int gic_present;
unsigned long _gic_base;
@@ -467,3 +473,97 @@ void __init gic_init(unsigned long gic_base_addr,
gic_platform_init(numintrs, &gic_irq_controller);
}
+
+#ifdef CONFIG_IRQ_DOMAIN
+/* CPU core IRQs used by GIC */
+static int gic_cpu_pin[GIC_NUM_CPU_INT];
+static int num_gic_cpu_pins;
+
+static int gic_irq_domain_map(struct irq_domain *d, unsigned int irq,
+ irq_hw_number_t hw)
+{
+ int pin = gic_cpu_pin[0] - GIC_CPU_PIN_OFFSET;
+
+ irq_set_chip_and_handler(irq, &gic_irq_controller, handle_level_irq);
+
+ GICWRITE(GIC_REG_ADDR(SHARED, GIC_SH_MAP_TO_PIN(hw)),
+ GIC_MAP_TO_PIN_MSK | pin);
+ /* Map to VPE 0 by default */
+ GIC_SH_MAP_TO_VPE_SMASK(hw, 0);
+ set_bit(hw, pcpu_masks[0].pcpu_mask);
+
+ return 0;
+}
+
+static const struct irq_domain_ops gic_irq_domain_ops = {
+ .map = gic_irq_domain_map,
+ .xlate = irq_domain_xlate_twocell,
+};
+
+static void gic_irq_dispatch(unsigned int irq, struct irq_desc *desc)
+{
+ struct irq_domain *domain = irq_get_handler_data(irq);
+ unsigned int hwirq;
+
+ while ((hwirq = gic_get_int()) != GIC_NUM_INTRS) {
+ irq = irq_linear_revmap(domain, hwirq);
+ generic_handle_irq(irq);
+ }
+}
+
+void __weak __init gic_platform_init(int irqs, struct irq_chip *irq_controller)
+{
+}
+
+int __init gic_of_init(struct device_node *node, struct device_node *parent)
+{
+ struct irq_domain *domain;
+ struct resource res;
+ int i;
+
+ if (cpu_has_veic) {
+ pr_err("GIC EIC mode not supported with DT yet\n");
+ return -ENODEV;
+ }
+
+ for (i = 0; i < ARRAY_SIZE(gic_cpu_pin); i++) {
+ if (of_property_read_u32_index(node,
+ "mti,available-cpu-vectors",
+ i, &gic_cpu_pin[i]))
+ break;
+ num_gic_cpu_pins++;
+ }
+ if (!num_gic_cpu_pins) {
+ pr_err("No available CPU interrupt vectors for GIC\n");
+ return -ENODEV;
+ }
+
+ if (of_address_to_resource(node, 0, &res)) {
+ pr_err("Failed to get GIC memory range\n");
+ return -ENODEV;
+ }
+
+ if (mips_cm_present())
+ write_gcr_gic_base(res.start | CM_GCR_GIC_BASE_GICEN_MSK);
+
+ gic_init(res.start, resource_size(&res), NULL, 0, MIPS_GIC_IRQ_BASE);
+
+ domain = irq_domain_add_legacy(node, GIC_NUM_INTRS, MIPS_GIC_IRQ_BASE,
+ 0, &gic_irq_domain_ops, NULL);
+ if (!domain) {
+ pr_err("Failed to add GIC IRQ domain\n");
+ return -ENOMEM;
+ }
+
+ for (i = 0; i < num_gic_cpu_pins; i++) {
+ int irq;
+
+ irq = irq_create_mapping(mips_intc_domain, gic_cpu_pin[i]);
+ irq_set_chained_handler(irq, gic_irq_dispatch);
+ irq_set_handler_data(irq, domain);
+ }
+
+ return 0;
+}
+IRQCHIP_DECLARE(mips_gic, "mti,global-interrupt-controller", gic_of_init);
+#endif
--
2.1.0.rc2.206.gedb03e5
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
