Dear Bartosz,
Thanks for your comments!
On Tue, 2022-01-25 at 11:21 +0100, Bartosz Golaszewski wrote:
> On Thu, Jan 20, 2022 at 8:02 AM Biao Huang <biao.huang@xxxxxxxxxxxx>
> wrote:
> >
> > Add Ethernet driver support for MT8365 SoC.
> >
> > Signed-off-by: Biao Huang <biao.huang@xxxxxxxxxxxx>
> > Signed-off-by: Yinghua Pan <ot_yinghua.pan@xxxxxxxxxxxx>
> > Signed-off-by: Fabien Parent <fparent@xxxxxxxxxxxx>
> > ---
> > drivers/net/ethernet/mediatek/mtk_star_emac.c | 75
> > ++++++++++++++++---
> > 1 file changed, 64 insertions(+), 11 deletions(-)
> >
> > diff --git a/drivers/net/ethernet/mediatek/mtk_star_emac.c
> > b/drivers/net/ethernet/mediatek/mtk_star_emac.c
> > index 7c2af775d601..403439782db9 100644
> > --- a/drivers/net/ethernet/mediatek/mtk_star_emac.c
> > +++ b/drivers/net/ethernet/mediatek/mtk_star_emac.c
> > @@ -151,6 +151,7 @@ static const char *const mtk_star_clk_names[] =
> > { "core", "reg", "trans" };
> > #define MTK_STAR_REG_MAC_CLK_CONF 0x00ac
> > #define MTK_STAR_MSK_MAC_CLK_CONF GENMASK(7, 0)
> > #define MTK_STAR_BIT_CLK_DIV_10 0x0a
> > +#define MTK_STAR_BIT_CLK_DIV_50 0x32
> >
> > /* Counter registers. */
> > #define MTK_STAR_REG_C_RXOKPKT 0x0100
> > @@ -183,9 +184,11 @@ static const char *const mtk_star_clk_names[]
> > = { "core", "reg", "trans" };
> > #define MTK_STAR_REG_C_RX_TWIST 0x0218
> >
> > /* Ethernet CFG Control */
> > -#define MTK_PERICFG_REG_NIC_CFG_CON 0x03c4
> > -#define MTK_PERICFG_MSK_NIC_CFG_CON_CFG_MII GENMASK(3, 0)
> > -#define MTK_PERICFG_BIT_NIC_CFG_CON_RMII BIT(0)
> > +#define MTK_PERICFG_REG_NIC_CFG0_CON 0x03c4
> > +#define MTK_PERICFG_REG_NIC_CFG1_CON 0x03c8
> > +#define MTK_PERICFG_REG_NIC_CFG_CON_V2 0x0c10
> > +#define MTK_PERICFG_REG_NIC_CFG_CON_CFG_INTF GENMASK(3, 0)
> > +#define MTK_PERICFG_BIT_NIC_CFG_CON_RMII 1
> >
> > /* Represents the actual structure of descriptors used by the MAC.
> > We can
> > * reuse the same structure for both TX and RX - the layout is the
> > same, only
> > @@ -234,6 +237,7 @@ struct mtk_star_ring {
> > };
> >
> > struct mtk_star_compat {
> > + int (*set_interface_mode)(struct net_device *ndev);
> > unsigned char bit_clk_div;
> > };
> >
> > @@ -909,13 +913,6 @@ static void mtk_star_init_config(struct
> > mtk_star_priv *priv)
> > priv->compat_data->bit_clk_div);
> > }
> >
> > -static void mtk_star_set_mode_rmii(struct mtk_star_priv *priv)
> > -{
> > - regmap_update_bits(priv->pericfg,
> > MTK_PERICFG_REG_NIC_CFG_CON,
> > - MTK_PERICFG_MSK_NIC_CFG_CON_CFG_MII,
> > - MTK_PERICFG_BIT_NIC_CFG_CON_RMII);
> > -}
> > -
> > static int mtk_star_enable(struct net_device *ndev)
> > {
> > struct mtk_star_priv *priv = netdev_priv(ndev);
> > @@ -1531,7 +1528,13 @@ static int mtk_star_probe(struct
> > platform_device *pdev)
> > return -ENODEV;
> > }
> >
> > - mtk_star_set_mode_rmii(priv);
> > + if (priv->compat_data->set_interface_mode) {
> > + ret = priv->compat_data->set_interface_mode(ndev);
> > + if (ret) {
> > + dev_err(dev, "Failed to set phy interface,
> > err = %d\n", ret);
> > + return -EINVAL;
> > + }
> > + }
>
> Shouldn't you still call mtk_star_set_mode_rmii(priv) if there's no
> callback?
mtk_star_set_mode_rmii is replaced by priv->compat_data-
>set_interface_mode,
all the interface settings are moved to set_interface_mode,
and we'll implement it for every IC.
so, mtk_star_set_mode_rmii is no longer used.
>
> >
> > ret = dma_set_mask_and_coherent(dev, DMA_BIT_MASK(32));
> > if (ret) {
> > @@ -1564,10 +1567,58 @@ static int mtk_star_probe(struct
> > platform_device *pdev)
> > return devm_register_netdev(dev, ndev);
> > }
> >
> > +static int mt8516_set_interface_mode(struct net_device *ndev)
> > +{
> > + struct mtk_star_priv *priv = netdev_priv(ndev);
> > + struct device *dev = mtk_star_get_dev(priv);
> > + unsigned int intf_val = 0;
>
> No need to initialize.
OK, will fix it in next send.
>
> > +
> > + switch (priv->phy_intf) {
> > + case PHY_INTERFACE_MODE_RMII:
> > + intf_val = MTK_PERICFG_BIT_NIC_CFG_CON_RMII;
> > + break;
> > + default:
> > + dev_err(dev, "This interface not supported\n");
> > + return -EINVAL;
> > + }
> > +
> > + regmap_update_bits(priv->pericfg,
> > MTK_PERICFG_REG_NIC_CFG0_CON,
> > + MTK_PERICFG_REG_NIC_CFG_CON_CFG_INTF,
> > + intf_val);
> > + return 0;
>
> You can directly return regmap_update_bits().
OK, will fix it in next send.
>
> > +}
> > +
> > +static int mt8365_set_interface_mode(struct net_device *ndev)
> > +{
> > + struct mtk_star_priv *priv = netdev_priv(ndev);
> > + struct device *dev = mtk_star_get_dev(priv);
> > + unsigned int intf_val = 0;
> > +
> > + switch (priv->phy_intf) {
> > + case PHY_INTERFACE_MODE_RMII:
> > + intf_val = MTK_PERICFG_BIT_NIC_CFG_CON_RMII;
> > + break;
> > + default:
> > + dev_err(dev, "This interface not supported\n");
> > + return -EINVAL;
> > + }
> > +
> > + regmap_update_bits(priv->pericfg,
> > MTK_PERICFG_REG_NIC_CFG_CON_V2,
> > + MTK_PERICFG_REG_NIC_CFG_CON_CFG_INTF,
> > + intf_val);
> > + return 0;
> > +}
>
> Same as above.
OK, will fix it in next send.
>
> > +
> > static struct mtk_star_compat mtk_star_mt8516_compat = {
> > + .set_interface_mode = mt8516_set_interface_mode,
> > .bit_clk_div = MTK_STAR_BIT_CLK_DIV_10,
> > };
> >
> > +static struct mtk_star_compat mtk_star_mt8365_compat = {
> > + .set_interface_mode = mt8365_set_interface_mode,
> > + .bit_clk_div = MTK_STAR_BIT_CLK_DIV_50,
> > +};
> > +
> > static const struct of_device_id mtk_star_of_match[] = {
> > { .compatible = "mediatek,mt8516-eth",
> > .data = &mtk_star_mt8516_compat },
> > @@ -1575,6 +1626,8 @@ static const struct of_device_id
> > mtk_star_of_match[] = {
> > .data = &mtk_star_mt8516_compat },
> > { .compatible = "mediatek,mt8175-eth",
> > .data = &mtk_star_mt8516_compat },
> > + { .compatible = "mediatek,mt8365-eth",
> > + .data = &mtk_star_mt8365_compat },
> > { }
> > };
> > MODULE_DEVICE_TABLE(of, mtk_star_of_match);
> > --
> > 2.25.1
> >
>
> Bart
