> Wiadomość napisana przez Peter Geis <pgwipeout@xxxxxxxxx> w dniu 28.07.2021, o godz. 15:55:
>
> Add the thermal and tsadc nodes to the rk3568 device tree.
> There are two sensors, one for the cpu, one for the gpu.
>
> Signed-off-by: Peter Geis <pgwipeout@xxxxxxxxx>
> ---
> .../boot/dts/rockchip/rk3568-pinctrl.dtsi | 6 ++
> arch/arm64/boot/dts/rockchip/rk356x.dtsi | 71 +++++++++++++++++++
> 2 files changed, 77 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/rockchip/rk3568-pinctrl.dtsi b/arch/arm64/boot/dts/rockchip/rk3568-pinctrl.dtsi
> index a588ca95ace2..b464c7bda1f7 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3568-pinctrl.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk3568-pinctrl.dtsi
> @@ -2420,6 +2420,12 @@ spi3m1_cs1: spi3m1-cs1 {
> };
>
> tsadc {
> + /omit-if-no-ref/
> + tsadc_gpio: tsadc-gpio {
> + rockchip,pins =
> + <0 RK_PA1 0 &pcfg_pull_none>;
> + };
> +
> /omit-if-no-ref/
> tsadcm0_shut: tsadcm0-shut {
> rockchip,pins =
> diff --git a/arch/arm64/boot/dts/rockchip/rk356x.dtsi b/arch/arm64/boot/dts/rockchip/rk356x.dtsi
> index 77c679304916..0905fac0726a 100644
> --- a/arch/arm64/boot/dts/rockchip/rk356x.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk356x.dtsi
> @@ -51,6 +51,7 @@ cpu0: cpu@0 {
> compatible = "arm,cortex-a55";
> reg = <0x0 0x0>;
> clocks = <&scmi_clk 0>;
> + #cooling-cells = <2>;
> enable-method = "psci";
> operating-points-v2 = <&cpu0_opp_table>;
> };
> @@ -59,6 +60,7 @@ cpu1: cpu@100 {
> device_type = "cpu";
> compatible = "arm,cortex-a55";
> reg = <0x0 0x100>;
> + #cooling-cells = <2>;
> enable-method = "psci";
> operating-points-v2 = <&cpu0_opp_table>;
> };
> @@ -67,6 +69,7 @@ cpu2: cpu@200 {
> device_type = "cpu";
> compatible = "arm,cortex-a55";
> reg = <0x0 0x200>;
> + #cooling-cells = <2>;
> enable-method = "psci";
> operating-points-v2 = <&cpu0_opp_table>;
> };
> @@ -75,6 +78,7 @@ cpu3: cpu@300 {
> device_type = "cpu";
> compatible = "arm,cortex-a55";
> reg = <0x0 0x300>;
> + #cooling-cells = <2>;
> enable-method = "psci";
> operating-points-v2 = <&cpu0_opp_table>;
> };
> @@ -774,6 +778,73 @@ uart9: serial@fe6d0000 {
> status = "disabled";
> };
>
> + thermal_zones: thermal-zones {
> + cpu_thermal: cpu-thermal {
> + polling-delay-passive = <100>;
> + polling-delay = <1000>;
> +
> + thermal-sensors = <&tsadc 0>;
> +
> + trips {
> + cpu_alert0: cpu_alert0 {
> + temperature = <70000>;
> + hysteresis = <2000>;
> + type = "passive";
> + };
> + cpu_alert1: cpu_alert1 {
> + temperature = <75000>;
> + hysteresis = <2000>;
> + type = "passive";
> + };
> + cpu_crit: cpu_crit {
> + temperature = <95000>;
> + hysteresis = <2000>;
> + type = "critical";
> + };
> + };
> +
> + cooling-maps {
> + map0 {
> + trip = <&cpu_alert0>;
> + cooling-device =
> + <&cpu0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
> + <&cpu1 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
> + <&cpu2 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
> + <&cpu3 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
> + };
> + };
> + };
> +
> + gpu_thermal: gpu-thermal {
> + polling-delay-passive = <20>; /* milliseconds */
> + polling-delay = <1000>; /* milliseconds */
> +
> + thermal-sensors = <&tsadc 1>;
> + };
> + };
> +
> + tsadc: tsadc@fe710000 {
> + compatible = "rockchip,rk3568-tsadc";
> + reg = <0x0 0xfe710000 0x0 0x100>;
> + interrupts = <GIC_SPI 115 IRQ_TYPE_LEVEL_HIGH>;
> + assigned-clocks = <&cru CLK_TSADC_TSEN>, <&cru CLK_TSADC>;
> + assigned-clock-rates = <17000000>, <700000>;
> + clocks = <&cru CLK_TSADC>, <&cru PCLK_TSADC>;
> + clock-names = "tsadc", "apb_pclk";
> + resets = <&cru SRST_TSADC>, <&cru SRST_P_TSADC>,
> + <&cru SRST_TSADCPHY>;
> + reset-names = "tsadc", "tsadc-apb", "tsadc-phy";
> + rockchip,grf = <&grf>;
> + rockchip,hw-tshut-temp = <95000>;
> + rockchip,hw-tshut-mode = <1>; /* tshut mode 0:CRU 1:GPIO */
> + rockchip,hw-tshut-polarity = <0>; /* tshut polarity 0:LOW 1:HIGH */
> + pinctrl-names = "gpio", "otpout";
> + pinctrl-0 = <&tsadc_gpio>;
> + pinctrl-1 = <&tsadc_shutorg>;
> + #thermal-sensor-cells = <1>;
> + status = "disabled";
> + };
> +
> saradc: saradc@fe720000 {
> compatible = "rockchip,rk3568-saradc", "rockchip,rk3399-saradc";
> reg = <0x0 0xfe720000 0x0 0x100>;
> --
> 2.25.1
>
>
> _______________________________________________
> Linux-rockchip mailing list
> Linux-rockchip@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-rockchip
Peter,
I'm trying to use this series to get thermal on rk3566 based tvbox (x96-x6).
Driver loads but i'm getting following error:
[ 132.873979] rockchip-thermal fe710000.tsadc: failed to register sensor 0: -517
[ 132.874650] rockchip-thermal fe710000.tsadc: failed to register sensor[0] : error = -517
Maybe you have some hints here?
