On some boards, for routing CAN signals from controller to transceivers,
muxes might need to be set. This can be implemented using mux-states
property. Therefore, document the same in the respective bindings.
Signed-off-by: Aswath Govindraju <a-govindraju@xxxxxx>
---
Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
index 6107880e5246..02b76f15e717 100644
--- a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
+++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
@@ -37,6 +37,12 @@ properties:
max bit rate supported in bps
minimum: 1
+ mux-states:
+ description:
+ mux controller node to route the signals from controller to
+ transceiver.
+ maxItems: 1
+
required:
- compatible
- '#phy-cells'
@@ -53,4 +59,5 @@ examples:
max-bitrate = <5000000>;
standby-gpios = <&wakeup_gpio1 16 GPIO_ACTIVE_LOW>;
enable-gpios = <&main_gpio1 67 GPIO_ACTIVE_HIGH>;
+ mux-states = <&mux0 1>;
};
--
2.17.1
