A pinctrl handle is used to setup a pull-up on the stusb1600 IRQ pin (that
is open drain).
When in ANALOG state, no pull-up can be applied in the GPIO HW controller,
still the setting is done into the register. The pull-up is effective
currently, only when the GPIO IRQ is requested. The correct setting is to
use directly the GPIO, instead of ANALOG state.
Signed-off-by: Fabrice Gasnier <fabrice.gasnier@xxxxxxxxxxx>
---
arch/arm/boot/dts/stm32mp15-pinctrl.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi b/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
index 5f060fe..3b65130 100644
--- a/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
@@ -1718,7 +1718,7 @@
stusb1600_pins_a: stusb1600-0 {
pins {
- pinmux = <STM32_PINMUX('I', 11, ANALOG)>;
+ pinmux = <STM32_PINMUX('I', 11, GPIO)>;
bias-pull-up;
};
};
--
2.7.4
