On Tue, Aug 19, 2014 at 02:14:47PM +0200, Frans Klaver wrote:
> At 3.6Mbaud, with slightly over 2Mbit/s data coming in, we see 1600 uart
> rx buffer overflows within 30 seconds. Threading the interrupt handling reduces
> this to about 170 overflows in 10 minutes.
Can you try Sebastian Siewior's patches for 8250_omap and 8250 dma
support ? That should help you a lot.
> In practice this therefore reduces the need for hardware flow control,
> meaning the sending side doesn't have to buffer as much either.
>
> Signed-off-by: Frans Klaver <frans.klaver@xxxxxxxxx>
> ---
> drivers/tty/serial/omap-serial.c | 31 ++++++++++++++++++++++++-------
> 1 file changed, 24 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
> index 14a0167..57664b9 100644
> --- a/drivers/tty/serial/omap-serial.c
> +++ b/drivers/tty/serial/omap-serial.c
> @@ -575,6 +575,21 @@ static void serial_omap_rdi(struct uart_omap_port *up, unsigned int lsr)
> }
>
> /**
> + * serial_omap_fast_irq() - schedule interrupt handling
> + */
> +static irqreturn_t serial_omap_fast_irq(int irq, void *dev_id)
> +{
> + struct uart_omap_port *up = dev_id;
> + unsigned int iir = serial_in(up, UART_IIR);
> +
> + if (iir & UART_IIR_NO_INT)
> + return IRQ_NONE;
> +
> + disable_irq_nosync(up->port.irq);
NAK. Either use IRQF_ONESHOT or actually mask the IRQs at the device's
registers (basically clearing IER).
--
balbi
Attachment:
signature.asc
Description: Digital signature
