On 11/12/21 8:07 AM, Krzysztof Kozlowski wrote:
On 12/11/2021 17:02, Luca Ceresoli wrote:
Hi Guenter,
On 12/11/21 15:57, Guenter Roeck wrote:
On 11/11/21 2:58 PM, Luca Ceresoli wrote:
Add a simple driver to support the watchdog embedded in the Maxim
MAX77714
PMIC.
Signed-off-by: Luca Ceresoli <luca@xxxxxxxxxxxxxxxx>
I just realized that this is effectively a rewrite of
drivers/watchdog/max77620_wdt.c.
The only difference I can see is is the register offsets (0x91 and 0x92
vs. 1 and 2) and some implementation details. Please add support for this
watchdog to the other driver or provide a _really_ good reason why that
is not possible.
I initially started developing MAX77714 watchdog support as an addition
to max77620_wdt.c as the procedures look identical at least for the
basic features.
But the register content seems completely different. Here are the notes
I took at that time:
-------------------------8<-------------------------
MAX77620 has reg ONOFFCNFG1 at 0x41, ONOFFCNFG2 at 0x42.
MAX77714 has reg CNFG1_ONOFF at 0x93, CNFG2_ONOFF at 0x94.
OK, we can handle this with a register indirection table, indexed by
chip model.
MAX77620 has MAX77620_REG_FPS_CFG0 register.
On MAX77714 I was unable to find any such register (I haven't looked at
FPS in detail though).
OK, we can handle this with some if()s or entirely disable PM on the
77714 until anybody cares.
MAX77620 ONOFFCNFG1 has SFT_RST in bit 7.
MAX77714 CNFG1_ONOFF has SFT_RST is bit 6.
Uhm, should we have a _bit_ indirection table in addition to the
_register_ indirection table?
MAX77620 ONOFFCNFG2 bit 5 is SLP_LPM_MSK, involved in FPS.
MAX77620 ONOFFCNFG2 bit 6 is WD_RTS_WK, configures the watchdog timer.
MAX77714 CNFG2_ONOFF bit 5 is WD_RTS_WK, configures the watchdog timer.
On MAX77714 I haven't found SLP_LPM_MSK.
MAX77620 has 6 CID registers with "ES version" in CID5.
MAX77714 has 5 CID registers with "DEVICE id" in CID3.
CID registers would be useful to get the chip model directly from the
chip, if only they had the same structure.
Almost all of the registers I have been looking into have similar
differences.
-------------------------8<-------------------------
When I started adding indirection tables the driver started growing
bigger and uglier, and that little simple driver started being big and
complex. So I opted to add a new driver.
The register offset differences are trivial and we do it in several
drivers. Also in rtc-max77686 used by you here.
Lack of features as well - just have a variant/driver data which defines
certain features (true/false) or quirk bits (see s3c2410_wdt).
The second driver - s3c2410_wdt - also customizes the bits.
Therefore if the generic device operating configuration is similar (same
generic control flow) and differences are in bits and offsets, then it
should be one driver.
Exactly.
Thanks,
Guenter
