This patch makes dwmac-mediatek reuse more features supported by stmmac_platform.c. Signed-off-by: Biao Huang <biao.huang@xxxxxxxxxxxx> --- .../ethernet/stmicro/stmmac/dwmac-mediatek.c | 32 +++++++++---------- 1 file changed, 15 insertions(+), 17 deletions(-) diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c index 157ff655c85e..6ea972e96665 100644 --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c @@ -335,22 +335,20 @@ static int mediatek_dwmac_init(struct platform_device *pdev, void *priv) const struct mediatek_dwmac_variant *variant = plat->variant; int ret; - ret = dma_set_mask_and_coherent(plat->dev, DMA_BIT_MASK(variant->dma_bit_mask)); - if (ret) { - dev_err(plat->dev, "No suitable DMA available, err = %d\n", ret); - return ret; - } - - ret = variant->dwmac_set_phy_interface(plat); - if (ret) { - dev_err(plat->dev, "failed to set phy interface, err = %d\n", ret); - return ret; + if (variant->dwmac_set_phy_interface) { + ret = variant->dwmac_set_phy_interface(plat); + if (ret) { + dev_err(plat->dev, "failed to set phy interface, err = %d\n", ret); + return ret; + } } - ret = variant->dwmac_set_delay(plat); - if (ret) { - dev_err(plat->dev, "failed to set delay value, err = %d\n", ret); - return ret; + if (variant->dwmac_set_delay) { + ret = variant->dwmac_set_delay(plat); + if (ret) { + dev_err(plat->dev, "failed to set delay value, err = %d\n", ret); + return ret; + } } ret = clk_bulk_prepare_enable(plat->num_clks_to_config, plat->clks); @@ -423,15 +421,15 @@ static int mediatek_dwmac_probe(struct platform_device *pdev) return PTR_ERR(plat_dat); plat_dat->interface = priv_plat->phy_mode; - plat_dat->has_gmac4 = 1; - plat_dat->has_gmac = 0; - plat_dat->pmt = 0; + plat_dat->use_phy_wol = 1; plat_dat->riwt_off = 1; plat_dat->maxmtu = ETH_DATA_LEN; + plat_dat->addr64 = priv_plat->variant->dma_bit_mask; plat_dat->bsp_priv = priv_plat; plat_dat->init = mediatek_dwmac_init; plat_dat->exit = mediatek_dwmac_exit; plat_dat->clks_config = mediatek_dwmac_clks_config; + mediatek_dwmac_init(pdev, priv_plat); ret = stmmac_dvr_probe(&pdev->dev, plat_dat, &stmmac_res); -- 2.25.1