On Wed, 06 Oct 2021, Krzysztof Kozlowski wrote: > Hi All, > > Changes since v2 > ================ > 1. Add Rob's tags. > 2. Remove "regulator-name" from properties (all regulator dtschema). > 3. Move "unevaluatedProperties" higher to make code easier to read (all regulator dtschema). > 4. Add ref-type to op-mode property (patch 6: s5m8767 regulators). > > Changes since v1 > ================ > 1. Drop DTS patches - applied. > 2. Fully remove bindings/regulator/samsung,s5m8767.txt . > 3. Minor subject reformatting and few typos in text. > > > Intro > ===== > This patchset converts all devicetree bindings of Samsung S2M and S5M > PMIC devices from txt to dtschema. > > It includes also two fixes because later conversion depends on it > (contextually). > > > Merging/dependencies > ==================== > 1. Regulator related binding changes depend on first two commits (the > fixes), because of context. > 2. The mfd bindings depend on clock and regulator bindings. > > The fixes and bindings changes (patches 1-10) should go via the same > tree. For example regulator or mfd tree. > > Another alternative is that regulator patches (1-2, 4-6) go via Mark who > later gives MFD a stable branch/tag to pull. Then the clock and MFD > bindings would go on top via MFD tree. Or any other setup you would like > to have. :) > > > Overview of devices > =================== > Essentially all Samsung S2M and S5M PMICs are very similar devices. They > provide the same functionality: regulators, RTC, 2 or 3 clocks and main > power management (e.g. power cut to SoC). > > The differences are mostly in registers layout and number of regulators. > > The drivers are built around one common part, mfd/sec-core.c, and share > some drivers between devices: > 1. MFD sec-core for all devices, > 1. one clock driver for most of devices, > 2. one RTC driver for all devices, > 3. three regulator drivers. > > The regulator drivers were implementing slightly different features, > therefore one regulator binding for all devices does not make much > sense. However the clock device binding can be shared. > > The final dtschema bindings try to implement this - share only the clock > bindings. > > Best regards, > Krzysztof > > Krzysztof Kozlowski (10): > regulator: s5m8767: do not use reset value as DVS voltage if GPIO DVS > is disabled > regulator: dt-bindings: samsung,s5m8767: correct > s5m8767,pmic-buck-default-dvs-idx property > dt-bindings: clock: samsung,s2mps11: convert to dtschema > regulator: dt-bindings: samsung,s2m: convert to dtschema > regulator: dt-bindings: samsung,s2mpa01: convert to dtschema > regulator: dt-bindings: samsung,s5m8767: convert to dtschema > dt-bindings: mfd: samsung,s2mps11: convert to dtschema > dt-bindings: mfd: samsung,s2mpa01: convert to dtschema > dt-bindings: mfd: samsung,s5m8767: convert to dtschema > dt-bindings: mfd: samsung,s5m8767: document buck and LDO supplies Looks like these are ready to be pushed. However, I am not in receipt of patches 1-2. Am I okay to merge 3-10 right now? -- Lee Jones [李琼斯] Senior Technical Lead - Developer Services Linaro.org │ Open source software for Arm SoCs Follow Linaro: Facebook | Twitter | Blog
