On 08/14/2014 07:03 AM, Sakari Ailus wrote:
Hi Jacek,
On Thu, Aug 07, 2014 at 10:21:14AM +0200, Jacek Anaszewski wrote:
On 08/06/2014 08:53 AM, Sakari Ailus wrote:
Hi Jacek,
On Fri, Jul 11, 2014 at 04:04:03PM +0200, Jacek Anaszewski wrote:
...
1) Who should register V4L2 Flash sub-device?
LED Flash Class devices, after introduction of the Flash Manager,
are not tightly coupled with any media controller. They are maintained
by the Flash Manager and made available for dynamic assignment to
any media system they are connected to through multiplexing devices.
In the proposed rough solution, when support for V4L2 Flash sub-devices
is enabled, there is a v4l2_device created for them to register in.
This however implies that V4L2 Flash device will not be available
in any media controller, which calls its existence into question.
Therefore I'd like to consult possible ways of solving this issue.
The option I see is implementing a mechanism for moving V4L2 Flash
sub-devices between media controllers. A V4L2 Flash sub-device
would initially be assigned to one media system in the relevant
device tree binding, but it could be dynamically reassigned to
the other one. However I'm not sure if media controller design
is prepared for dynamic modifications of its graph and how many
modifications in the existing drivers this solution would require.
Do you have a use case where you would need to strobe a flash from multiple
media devices at different times, or is this entirely theoretical? Typically
flash controllers are connected to a single source of hardware strobe (if
there's one) since the flash LEDs are in fact mounted next to a specific
camera sensor.
I took into account such arrangements in response to your message
[1], where you were considering configurations like "one flash but
two
cameras", "one camera and two flashes". And you also called for
proposing generic solution.
One flash and two (or more) cameras case is easily conceivable -
You even mentioned stereo cameras. One camera and many flashes
arrangement might be useful in case of some professional devices which
might be designed so that they would be able to apply different scene
lighting. I haven't heard about such devices, but as you said
such a configuration isn't unthinkable.
If this is a real issue the way to solve it would be to have a single media
device instead of many.
I was considering adding media device, that would be a representation
of a flash manager, gathering all the registered flashes. Nonetheless,
finally I came to conclusion that a v4l2-device alone should suffice,
just to provide a Flash Manager representation allowing for
v4l2-flash sub-devices to register in.
All the features provided by the media device are useless in case
of a set of V4L2 Flash sub-devices. They couldn't have any linkage
in such a device. The only benefit from having media device gathering
V4L2 Flash devices would be possibility of listing them.
Not quite so. The flash is associated to the sensor (and lens) using the
group ID in the Media controller. The user space doesn't need to "know" this
association.
More complex use cases such as the above may need extensions to the Media
controller API.
I think that I have unnecessarily complicated the issue. Generally
there will be always one media controller created for all camera
sensors available in the system. If there is a single media controller
then we can easily use async subdev registration API. A media-dev
driver would have to parse list of flash device phandles from
the ISP device's DT node and register them as async sub-devices.
Best Regards,
Jacek Anaszewski
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
