On the Quartz64 Model A, the I2S1 TDM controller is connected to the rk817 codec in I2S mode. Enabling it and adding the necessary simple-sound-card and codec nodes allows for analog audio output on the PINE64 Quartz64 Model A SBC. Signed-off-by: Nicolas Frattaroli <frattaroli.nicolas@xxxxxxxxx> --- .../boot/dts/rockchip/rk3566-quartz64-a.dts | 31 ++++++++++++++++++- 1 file changed, 30 insertions(+), 1 deletion(-) diff --git a/arch/arm64/boot/dts/rockchip/rk3566-quartz64-a.dts b/arch/arm64/boot/dts/rockchip/rk3566-quartz64-a.dts index a244f7b87e38..f1261f25cb35 100644 --- a/arch/arm64/boot/dts/rockchip/rk3566-quartz64-a.dts +++ b/arch/arm64/boot/dts/rockchip/rk3566-quartz64-a.dts @@ -58,6 +58,20 @@ led-diy { }; }; + rk817-sound { + compatible = "simple-audio-card"; + simple-audio-card,format = "i2s"; + simple-audio-card,name = "Analog RK817"; + simple-audio-card,mclk-fs = <256>; + + simple-audio-card,cpu { + sound-dai = <&i2s1_8ch>; + }; + simple-audio-card,codec { + sound-dai = <&rk817>; + }; + }; + vcc12v_dcin: vcc12v_dcin { compatible = "regulator-fixed"; regulator-name = "vcc12v_dcin"; @@ -199,8 +213,13 @@ rk817: pmic@20 { interrupts = <RK_PA3 IRQ_TYPE_LEVEL_LOW>; clock-output-names = "rk808-clkout1", "rk808-clkout2"; + #sound-dai-cells = <0>; + clock-names = "mclk"; + clocks = <&cru I2S1_MCLKOUT_TX>; + assigned-clocks = <&cru I2S1_MCLKOUT_TX>; + assigned-clock-parents = <&cru CLK_I2S1_8CH_TX>; pinctrl-names = "default"; - pinctrl-0 = <&pmic_int_l>; + pinctrl-0 = <&pmic_int_l>, <&i2s1m0_mclk>; rockchip,system-power-controller; wakeup-source; #clock-cells = <1>; @@ -392,6 +411,16 @@ regulator-state-mem { }; }; +&i2s1_8ch { + status = "okay"; + rockchip,trcm-sync-tx-only; + pinctrl-names = "default"; + pinctrl-0 = <&i2s1m0_sclktx + &i2s1m0_lrcktx + &i2s1m0_sdi0 + &i2s1m0_sdo0>; +}; + &mdio1 { rgmii_phy1: ethernet-phy@0 { compatible = "ethernet-phy-ieee802.3-c22"; -- 2.33.1