Hi Maxime, On Thu, Oct 14, 2021 at 09:41:10AM +0200, Maxime Ripard wrote: > On Wed, Oct 13, 2021 at 12:37:47PM +0300, Laurent Pinchart wrote: > > On Wed, Oct 13, 2021 at 09:47:22AM +0200, Maxime Ripard wrote: > > > On Tue, Oct 12, 2021 at 08:48:42AM +0200, Alexander Stein wrote: > > > > Add a VCC regulator which needs to be enabled before the EN pin is > > > > released. > > > > > > > > Reviewed-by: Sam Ravnborg <sam@xxxxxxxxxxxx> > > > > Signed-off-by: Alexander Stein <alexander.stein@xxxxxxxxxxxxxxx> > > > > --- > > > > .../devicetree/bindings/display/bridge/ti,sn65dsi83.yaml | 5 +++++ > > > > 1 file changed, 5 insertions(+) > > > > > > > > diff --git a/Documentation/devicetree/bindings/display/bridge/ti,sn65dsi83.yaml b/Documentation/devicetree/bindings/display/bridge/ti,sn65dsi83.yaml > > > > index a5779bf17849..49ace6f312d5 100644 > > > > --- a/Documentation/devicetree/bindings/display/bridge/ti,sn65dsi83.yaml > > > > +++ b/Documentation/devicetree/bindings/display/bridge/ti,sn65dsi83.yaml > > > > @@ -32,6 +32,9 @@ properties: > > > > maxItems: 1 > > > > description: GPIO specifier for bridge_en pin (active high). > > > > > > > > + vcc-supply: > > > > + description: A 1.8V power supply (see regulator/regulator.yaml). > > > > + > > > > ports: > > > > $ref: /schemas/graph.yaml#/properties/ports > > > > > > > > @@ -93,6 +96,7 @@ properties: > > > > required: > > > > - compatible > > > > - reg > > > > + - vcc-supply > > > > > > This isn't a backward-compatible change. All the previous users of that > > > binding will now require a vcc-supply property even though it was > > > working fine for them before. > > > > > > You handle that nicely in the code, but you can't make that new property > > > required. > > > > We can't make it required in the driver, but can't we make it required > > in the bindings ? This indicates that all new DTs need to set the > > property. We also need to mass-patch the in-tree DTs to avoid validation > > failures, but apart from that, I don't see any issue. > > I guess we'd need to clarify what the schemas are here for. > > We've been using them for two things: define the bindings, and make > sure that the users of a binding actually follow it. > > The second part makes it very tempting to also cram "and make sure they > follow our best practices" in there. We never had the discussion about > whether that's ok or not, and I think the schemas syntax falls a bit > short there since I don't think we can make the difference between a > warning and an error that would make it work. > > However, if we're talking about the binding itself, then no, you can't > introduce a new property. I assume you mean "a new required property" here. > Since it was acceptable in the past, it still needs to be acceptable > going forward. I think that's a matter of definition. The way I see it (but I could be mistaken), we're essentially versioning DT bindings without actually saying so, with the latest version being the visible one, and drivers having to preserve backward compatibility with new versions. We could also see it in different ways of course. What's important is in my opinion to make sure that new DTs will do the right thing, and if we don't make this property required, we can't check that. DT authors wouldn't know if the property is optional due to backward compatibility only but highly recommended, or really optional. -- Regards, Laurent Pinchart
