Hi, Charles. Thanks for your review. On Wed, 13 Aug 2014 13:18:14 +0100 Charles Keepax <ckeepax@xxxxxxxxxxxxxxxxxxxxxxxxxxx> wrote: > On Wed, Aug 13, 2014 at 08:54:56PM +0900, Inha Song wrote: > > This patch update DT binding to support INn_MODE init_data. Each > > input signal path can be configurated either as a Analogue or > > Digital using the INn_MODE registers. > > > > Signed-off-by: Inha Song <ideal.song@xxxxxxxxxxx> > > --- > > Documentation/devicetree/bindings/mfd/arizona.txt | 8 ++++++++ > > 1 file changed, 8 insertions(+) > > > > diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt > > index 5c7e723..b8c131e 100644 > > --- a/Documentation/devicetree/bindings/mfd/arizona.txt > > +++ b/Documentation/devicetree/bindings/mfd/arizona.txt > > @@ -42,6 +42,14 @@ Optional properties: > > the chip default will be used. If present exactly five values must > > be specified. > > > > + - wlf,inmode : A list of INn_MODE register values, where n is the number > > + of input signal. Each input signal path can be configurated either as a > > + Analogue or Digital using the INn_MODE registers. If absent, INn_MODE > > + registers set to 0 by default. If present, values must be specified less > > + than or equal to the number of input singal. If values less than the > > Typo here should be "input signals". Oops, Thanks! I will fix this. Best regards, Inha Song. > > > + number of input signal, elements that has not been specifed are set to 0 > > + by default. > > + > > - DCVDD-supply, MICVDD-supply : Power supplies, only need to be specified if > > they are being externally supplied. As covered in > > Documentation/devicetree/bindings/regulator/regulator.txt > > -- > > 2.0.0.390.gcb682f8 > > > > Thanks, > Charles -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
