Hi Peter, > Good Afternoon, > > This is my series to support the usb2 phy devices on the rk356x. > The rk356x phy has a single muxed interrupt and has moved the usb2phy > nodes out of the grf and into their own nodes. > The phy needs to tie back into the grf for register control, similar to > the rv1108. > By moving the phys into their own nodes, they now have full > #address_cells = 2 register addresses, but they still reside below the 32bit > mmio range. > > This driver series only supports the host configuration for the rk356x. > I have have tested it on the following: > rk3566 - Pine64 Quartz64 Model A > rk3399 - Pine64 Rockpro64 On a RK3568 EVB1 with suitable additions to the board dts: Tested-by: Michael Riesch <michael.riesch@xxxxxxxxxxxxxx> Thanks for your efforts and best regards, Michael > > Please provide feedback and comments as you see fit. > > Changelog: > v2: > - correct the order of the usb2phy-grf dt-bindings patch, thanks Johan > - correct the conditional requirements of phy-rockchip-inno-usb2, thanks > Johan > - drop increase generic-ohci clocks patch, thanks Heiko > - correct rk356x.dtsi ordering > - fix a dtbs-check callout > > Peter Geis (8): > dt-bindings: soc: rockchip: add rk3568-usb2phy-grf > dt-bindings: phy: phy-rockchip-inno-usb2: add rk3568 documentation > phy: phy-rockchip-inno-usb2: support #address_cells = 2 > phy: phy-rockchip-inno-usb2: support standalone phy nodes > phy: phy-rockchip-inno-usb2: support muxed interrupts > phy: phy-rockchip-inno-usb2: add rk3568 support > arm64: dts: rockchip: add usb2 nodes to rk3568 device tree > arm64: dts: rockchip: add Quartz64-A usb2 support > > .../bindings/phy/phy-rockchip-inno-usb2.yaml | 31 ++- > .../devicetree/bindings/soc/rockchip/grf.yaml | 1 + > .../boot/dts/rockchip/rk3566-quartz64-a.dts | 52 ++++ > arch/arm64/boot/dts/rockchip/rk356x.dtsi | 98 +++++++ > drivers/phy/rockchip/phy-rockchip-inno-usb2.c | 259 ++++++++++++++---- > 5 files changed, 383 insertions(+), 58 deletions(-) > > -- > 2.25.1 >
