There is no regulator bus in hardware. So move the regulator nodes out and remove the regulators simple-bus. This also make the dts align with the simple-bus schema. Signed-off-by: Li Yang <leoyang.li@xxxxxxx> --- arch/arm/boot/dts/ls1021a-qds.dts | 19 ++++++------------- arch/arm/boot/dts/ls1021a-twr.dts | 19 ++++++------------- 2 files changed, 12 insertions(+), 26 deletions(-) diff --git a/arch/arm/boot/dts/ls1021a-qds.dts b/arch/arm/boot/dts/ls1021a-qds.dts index 6db6604e7a18..6e469b46229f 100644 --- a/arch/arm/boot/dts/ls1021a-qds.dts +++ b/arch/arm/boot/dts/ls1021a-qds.dts @@ -25,19 +25,12 @@ sys_mclk: clock-mclk { clock-frequency = <24576000>; }; - regulators { - compatible = "simple-bus"; - #address-cells = <1>; - #size-cells = <0>; - - reg_3p3v: regulator@0 { - compatible = "regulator-fixed"; - reg = <0>; - regulator-name = "3P3V"; - regulator-min-microvolt = <3300000>; - regulator-max-microvolt = <3300000>; - regulator-always-on; - }; + reg_3p3v: regulator { + compatible = "regulator-fixed"; + regulator-name = "3P3V"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + regulator-always-on; }; sound { diff --git a/arch/arm/boot/dts/ls1021a-twr.dts b/arch/arm/boot/dts/ls1021a-twr.dts index e162a1599264..f5c03871b205 100644 --- a/arch/arm/boot/dts/ls1021a-twr.dts +++ b/arch/arm/boot/dts/ls1021a-twr.dts @@ -23,19 +23,12 @@ sys_mclk: clock-mclk { clock-frequency = <24576000>; }; - regulators { - compatible = "simple-bus"; - #address-cells = <1>; - #size-cells = <0>; - - reg_3p3v: regulator@0 { - compatible = "regulator-fixed"; - reg = <0>; - regulator-name = "3P3V"; - regulator-min-microvolt = <3300000>; - regulator-max-microvolt = <3300000>; - regulator-always-on; - }; + reg_3p3v: regulator { + compatible = "regulator-fixed"; + regulator-name = "3P3V"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + regulator-always-on; }; sound { -- 2.25.1