Document new binding qca,power_on_sel used to enable Power-on-strapping select reg and qca,led_open_drain to set led to open drain mode. Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx> --- Documentation/devicetree/bindings/net/dsa/qca8k.txt | 11 +++++++++++ 1 file changed, 11 insertions(+) diff --git a/Documentation/devicetree/bindings/net/dsa/qca8k.txt b/Documentation/devicetree/bindings/net/dsa/qca8k.txt index 05a8ddfb5483..71cd45818430 100644 --- a/Documentation/devicetree/bindings/net/dsa/qca8k.txt +++ b/Documentation/devicetree/bindings/net/dsa/qca8k.txt @@ -13,6 +13,17 @@ Required properties: Optional properties: - reset-gpios: GPIO to be used to reset the whole device +- qca,ignore-power-on-sel: Ignore power on pin strapping to configure led open + drain or eeprom presence. This is needed for broken + device that have wrong configuration or when the oem + decided to not use pin strapping and fallback to sw + regs. +- qca,led-open-drain: Set leds to open-drain mode. This require the + qca,ignore-power-on-sel to be set or the driver will fail + to probe. This is needed if the oem doesn't use pin + strapping to set this mode and prefer to set it using sw + regs. The pin strapping related to led open drain mode is + the pin B68 for QCA832x and B49 for QCA833x Subnodes: -- 2.32.0
