Hi Leo,
> -----Original Message-----
> From: Li Yang <leoyang.li@xxxxxxx>
> Sent: Friday, October 1, 2021 5:34 AM
> To: Shawn Guo <shawnguo@xxxxxxxxxx>; Rob Herring
> <robh+dt@xxxxxxxxxx>; devicetree@xxxxxxxxxxxxxxx; Oleksij Rempel
> <linux@xxxxxxxxxxxxxxxx>; linux-arm-kernel@xxxxxxxxxxxxxxxxxxx; linux-
> kernel@xxxxxxxxxxxxxxx
> Cc: Leo Li <leoyang.li@xxxxxxx>
> Subject: [EXT] [PATCH v2 04/16] ARM: dts: ls1021a-qds: Add node for QSPI
> flash
>
> Caution: EXT Email
>
> Add the missing node for qspi flash.
>
> Signed-off-by: Li Yang <leoyang.li@xxxxxxx>
> ---
> arch/arm/boot/dts/ls1021a-qds.dts | 15 +++++++++++++++
> 1 file changed, 15 insertions(+)
>
> diff --git a/arch/arm/boot/dts/ls1021a-qds.dts
> b/arch/arm/boot/dts/ls1021a-qds.dts
> index e2aa569ff404..522e1dc51059 100644
> --- a/arch/arm/boot/dts/ls1021a-qds.dts
> +++ b/arch/arm/boot/dts/ls1021a-qds.dts
> @@ -286,6 +286,21 @@ tbi0: tbi-phy@8 {
> };
> };
>
> +&qspi {
> + num-cs = <2>;
Please drop "num-cs" property as it is not used by qspi driver.
> + status = "okay";
> +
> + qflash0: flash@0 {
Can we have flash chip name instead of qflash?
There is no hard requirement, it will help in aligning node properties with other board properties such as LX2160A-RDB, LS1046A-RDB etc.
With above fixed,
Reviewed-by: Kuldeep Singh <kuldeep.singh@xxxxxxx>
> + compatible = "jedec,spi-nor";
> + #address-cells = <1>;
> + #size-cells = <1>;
> + spi-max-frequency = <20000000>;
> + reg = <0>;
> + spi-rx-bus-width = <4>;
> + spi-tx-bus-width = <4>;
> + };
> +};
> +
> &sai2 {
> status = "okay";
> };
> --
> 2.25.1
