On 28/09/2021 10:49, Krzysztof Kozlowski wrote: > Convert the regulators of Samsung S5M8767 PMIC to DT schema format. > > Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxxxxx> > --- > .../bindings/regulator/samsung,s5m8767.txt | 23 +---- > .../bindings/regulator/samsung,s5m8767.yaml | 83 +++++++++++++++++++ > MAINTAINERS | 2 +- > 3 files changed, 85 insertions(+), 23 deletions(-) > create mode 100644 Documentation/devicetree/bindings/regulator/samsung,s5m8767.yaml > > diff --git a/Documentation/devicetree/bindings/regulator/samsung,s5m8767.txt b/Documentation/devicetree/bindings/regulator/samsung,s5m8767.txt > index 6cd83d920155..a1c6eb6f07c8 100644 > --- a/Documentation/devicetree/bindings/regulator/samsung,s5m8767.txt > +++ b/Documentation/devicetree/bindings/regulator/samsung,s5m8767.txt > @@ -48,28 +48,7 @@ Additional properties required if either of the optional properties are used: > for dvs. The format of the gpio specifier depends in the gpio controller. > > > -Names of regulators supported by S5M8767 device: > - - LDOn > - - valid values for n are 1 to 28 > - - Example: LDO1, LDO2, LDO28 > - - BUCKn > - - valid values for n are 1 to 9. > - - Example: BUCK1, BUCK2, BUCK9 > -Note: The 'n' in LDOn and BUCKn represents the LDO or BUCK number > -as per the datasheet of device. > - > - > -Optional properties of the nodes under "regulators" sub-node: > - - op_mode: describes the different operating modes of the LDO's with > - power mode change in SOC. The different possible values are, > - 0 - always off mode > - 1 - on in normal mode > - 2 - low power mode > - 3 - suspend mode > - - s5m8767,pmic-ext-control-gpios: (optional) GPIO specifier for one > - GPIO controlling this regulator > - (enable/disable); This is valid only > - for buck9. > + That's obviously not sufficient - I will remove full file in v2. Best regards, Krzysztof
