On Mon, 16 Aug 2021 14:35:44 +0200, Stephan Gerhold wrote:
> So far there were no interrupts set up for the BMC150 accelerometer
> + magnetometer combo because they were broken for some reason.
> It turns out Longcheer L8150 actually has a BMC156 which is very similar
> to BMC150, but only has an INT2 pin for the accelerometer part.
>
> This requires some minor changes in the bmc150-accel driver which is now
> supported by using the more correct bosch,bmc156_accel compatible.
> Unfortunately it looks like even INT2 is not functional on most boards
> because the interrupt line is not actually connected to the BMC156.
> However, there are two pads next to the chip that can be shorted
> to make it work if needed.
>
> [...]
Applied, thanks!
[1/1] arm64: dts: qcom: msm8916-longcheer-l8150: Add missing sensor interrupts
commit: 51c7786f5d4201422e076b9a3650e543a61d36da
Best regards,
--
Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
