This patch documents the device tree bindings required for the
ehci on-chip controller found in ST consumer electronics SoC's.
Signed-off-by: Peter Griffin <peter.griffin@xxxxxxxxxx>
---
Documentation/devicetree/bindings/usb/ehci-st.txt | 41 +++++++++++++++++++++++
1 file changed, 41 insertions(+)
create mode 100644 Documentation/devicetree/bindings/usb/ehci-st.txt
diff --git a/Documentation/devicetree/bindings/usb/ehci-st.txt b/Documentation/devicetree/bindings/usb/ehci-st.txt
new file mode 100644
index 0000000..abb862a
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/ehci-st.txt
@@ -0,0 +1,41 @@
+ST USB EHCI controller
+
+Required properties:
+ - compatible : must be "st,st-ehci-300x"
+ - reg : physical base addresses of the controller and length of memory mapped
+ region
+ - interrupts : one EHCI interrupt should be described here
+ - pinctrl-names : a pinctrl state named "default" must be defined
+ - pinctrl-0 : phandle referencing pin configuration of the USB controller
+See: Documentation/devicetree/bindings/pinctrl/pinctrl-binding.txt
+
+Optional properties:
+ - clocks : phandle list of usb clocks
+ - clock-names : should be "ic" for interconnect clock and "clk48"
+See: Documentation/devicetree/bindings/clock/clock-bindings.txt
+
+ - phys : phandle for the PHY device
+ - phy-names : should be "usb"
+ - resets : phandle + reset specifier pairs to the powerdown and softreset lines
+ of the USB IP
+ - reset-names : should be "power" and "softreset"
+See: Documentation/devicetree/bindings/reset/st,sti-powerdown.txt
+See: Documentation/devicetree/bindings/reset/reset.txt
+
+Example:
+
+ ehci1: usb@0xfe203e00 {
+ compatible = "st,ehci-platform";
+ reg = <0xfe203e00 0x100>;
+ interrupts = <GIC_SPI 148 IRQ_TYPE_NONE>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_usb1>;
+ clocks = <&clk_s_a1_ls 0>;
+ phys = <&usb2_phy>;
+ phy-names = "usb";
+ status = "okay";
+
+ resets = <&powerdown STIH416_USB1_POWERDOWN>,
+ <&softreset STIH416_USB1_SOFTRESET>;
+ reset-names = "power", "softreset";
+ };
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
