Re: [PATCH] dt-bindings: hwmon: Add nct7802 bindings

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Guenter

> > Following the example from tmp421, this could then be like this:
>
> Something like that, only we'll need something to distinguish
> temperature sensors from other sensor types, eg voltage or current.
> Maybe a "type" property. I'd suggest "sensor-type", but we have
> non-sensor attributes such as fan count and pwm values which should
> be covered as well. But it looks like a good start for a set of
> generic sensor properties.
Would it be acceptable to simply number the sensors and document which
sensor has which number?

Something like this:
0 = LTD
1 = RTD1
2 = RTD2
3 = RTD3
4 = FAN1
5 = FAN2
6 = FAN3

Would we also want to be able to define PWMs? From what I can tell the
driver does not support running individual pins in GPIO mode, right?
So I'm not quite clear what "disabling PWM" would actually mean.

Anyway, if we simply go by "sensor number", that would mean that we'd
have different attributes depending on the sensor number. Would that
be ok?

Also, I'm sorry, I think I just realized that in "voltage mode" we
don't seem to get a temperature reading. I hadn't actually looked
through more of the datasheet except for the single MODE register
before. But I don't think this makes a difference for what I proposed
so far?

> >         /* LTD */
> >         input@0 {
> >             reg = <0x0>;
> >             status = "okay";
>
> Not sure what the default is here ('okay' or 'disabled').
> We'd also need to define what to do if there is no data
> for a given sensor.
I think I'd like to keep previous behavior unmodified. From what I can
tell previous behavior was:
- xTDs enabled by default
- RTD modes unmodified, i.e. defaulting to whatever the HW comes up with

The NCT7802Y can self-program from an EEPROM, so I assume we should
honor the "power-up configuration" obtained from there? I.e. if no
configuration is provided in the device tree, the driver should use
whatever configuration the chip has when the driver is loaded.

> >             label = "voltage mode";
>
> That isn't the idea for "label", as "label" would be expected to
> show up as tempX_label (and a label of "voltage mode" would be odd).
> The label should indicate where the sensor is located on a board,
> such as "inlet" or "outlet".
Yes, absolutely. This was a bad example on my part. In my
understanding "label" is just a string that we pass through.

Oskar.



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux