>On Fri, Sep 03, 2021 at 08:10:38AM +0000, Parshuram Raju Thombare wrote:
>
>> >> + master->mode_bits = SPI_3WIRE | SPI_TX_DUAL | SPI_TX_QUAD |
>> >> + SPI_RX_DUAL | SPI_RX_QUAD | SPI_TX_OCTAL | SPI_RX_OCTAL
>> >|
>> >> + SPI_MODE_0 | SPI_MODE_3;
>
>> >I don't see any handling of these in the code?
>
>> This is just to declare controller's capability, so that spi_setup() can modify
>> spi->mode according to the capability of attached device.
>
>In order for this to work I would expect there to be code in the driver
>which configures the controller into the specified mode.
Oh, ok. That is done at power on reset by the controller in 2 ways.
1. Using device discovery module, controller try to auto detect the valid protocol
mode by trying to read SFDP signature in various modes.
2. Particular protocol mode can be selected using bootstrap signals.
I think mode_bits need to include protocol mode which is auto detected or
set using bootstrap signals. I will make that change in next version.
Regards,
Parshuram Thombare
