There is no GPMC NOR compatible or device driver. GPMC is just
a bus interface over which standard (CFI/JEDC) NOR Flash chips
can be attached.
For NOR chip bindings, please refer to
Documentation/devicetree/bindings/mtd/mtd-physmap.yaml
For GPMC bus timing configuration, please refer to
Documentation/devicetree/bindings/memory-controllers/ti,gpmc.yaml
Signed-off-by: Roger Quadros <rogerq@xxxxxxxxxx>
---
.../devicetree/bindings/mtd/gpmc-nor.txt | 98 -------------------
1 file changed, 98 deletions(-)
delete mode 100644 Documentation/devicetree/bindings/mtd/gpmc-nor.txt
diff --git a/Documentation/devicetree/bindings/mtd/gpmc-nor.txt b/Documentation/devicetree/bindings/mtd/gpmc-nor.txt
deleted file mode 100644
index c9bea106ea65..000000000000
--- a/Documentation/devicetree/bindings/mtd/gpmc-nor.txt
+++ /dev/null
@@ -1,98 +0,0 @@
-Device tree bindings for NOR flash connect to TI GPMC
-
-NOR flash connected to the TI GPMC (found on OMAP boards) are represented as
-child nodes of the GPMC controller with a name of "nor".
-
-All timing relevant properties as well as generic GPMC child properties are
-explained in a separate documents. Please refer to
-Documentation/devicetree/bindings/memory-controllers/ti,gpmc.yaml
-
-Required properties:
-- bank-width: Width of NOR flash in bytes. GPMC supports 8-bit and
- 16-bit devices and so must be either 1 or 2 bytes.
-- compatible: Documentation/devicetree/bindings/mtd/mtd-physmap.txt
-- gpmc,cs-on-ns: Chip-select assertion time
-- gpmc,cs-rd-off-ns: Chip-select de-assertion time for reads
-- gpmc,cs-wr-off-ns: Chip-select de-assertion time for writes
-- gpmc,oe-on-ns: Output-enable assertion time
-- gpmc,oe-off-ns: Output-enable de-assertion time
-- gpmc,we-on-ns Write-enable assertion time
-- gpmc,we-off-ns: Write-enable de-assertion time
-- gpmc,access-ns: Start cycle to first data capture (read access)
-- gpmc,rd-cycle-ns: Total read cycle time
-- gpmc,wr-cycle-ns: Total write cycle time
-- linux,mtd-name: Documentation/devicetree/bindings/mtd/mtd-physmap.txt
-- reg: Chip-select, base address (relative to chip-select)
- and size of NOR flash. Note that base address will be
- typically 0 as this is the start of the chip-select.
-
-Optional properties:
-- gpmc,XXX Additional GPMC timings and settings parameters. See
- Documentation/devicetree/bindings/memory-controllers/ti,gpmc.yaml
-
-Optional properties for partition table parsing:
-- #address-cells: should be set to 1
-- #size-cells: should be set to 1
-
-Example:
-
-gpmc: gpmc@6e000000 {
- compatible = "ti,omap3430-gpmc", "simple-bus";
- ti,hwmods = "gpmc";
- reg = <0x6e000000 0x1000>;
- interrupts = <20>;
- gpmc,num-cs = <8>;
- gpmc,num-waitpins = <4>;
- #address-cells = <2>;
- #size-cells = <1>;
-
- ranges = <0 0 0x10000000 0x08000000>;
-
- nor@0,0 {
- compatible = "cfi-flash";
- linux,mtd-name= "intel,pf48f6000m0y1be";
- #address-cells = <1>;
- #size-cells = <1>;
- reg = <0 0 0x08000000>;
- bank-width = <2>;
-
- gpmc,mux-add-data;
- gpmc,cs-on-ns = <0>;
- gpmc,cs-rd-off-ns = <186>;
- gpmc,cs-wr-off-ns = <186>;
- gpmc,adv-on-ns = <12>;
- gpmc,adv-rd-off-ns = <48>;
- gpmc,adv-wr-off-ns = <48>;
- gpmc,oe-on-ns = <54>;
- gpmc,oe-off-ns = <168>;
- gpmc,we-on-ns = <54>;
- gpmc,we-off-ns = <168>;
- gpmc,rd-cycle-ns = <186>;
- gpmc,wr-cycle-ns = <186>;
- gpmc,access-ns = <114>;
- gpmc,page-burst-access-ns = <6>;
- gpmc,bus-turnaround-ns = <12>;
- gpmc,cycle2cycle-delay-ns = <18>;
- gpmc,wr-data-mux-bus-ns = <90>;
- gpmc,wr-access-ns = <186>;
- gpmc,cycle2cycle-samecsen;
- gpmc,cycle2cycle-diffcsen;
-
- partition@0 {
- label = "bootloader-nor";
- reg = <0 0x40000>;
- };
- partition@40000 {
- label = "params-nor";
- reg = <0x40000 0x40000>;
- };
- partition@80000 {
- label = "kernel-nor";
- reg = <0x80000 0x200000>;
- };
- partition@280000 {
- label = "filesystem-nor";
- reg = <0x240000 0x7d80000>;
- };
- };
-};
--
2.17.1
