Hi Bart, On 8/23/21 10:02 AM, Bartosz Golaszewski wrote: > On Wed, Aug 18, 2021 at 10:11 AM Piyush Mehta <piyush.mehta@xxxxxxxxxx> wrote: >> >> This patch adds driver support for the zynqmp modepin GPIO controller. >> GPIO modepin driver set and get the value and status of the PS_MODE pin, >> based on device-tree pin configuration. These four mode pins are >> configurable as input/output. The mode pin has a control register, which >> have lower four-bits [0:3] are configurable as input/output, next four-bits >> can be used for reading the data as input[4:7], and next setting the >> output pin state output[8:11]. >> >> Signed-off-by: Piyush Mehta <piyush.mehta@xxxxxxxxxx> >> Acked-by: Michal Simek <michal.simek@xxxxxxxxxx> >> Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx> >> --- > > Which tree should this go through? I would prefer to go this via gpio tree. Thanks, Michal
