On 07/30/2014 01:23 AM, David Collins wrote:
> On 07/24/2014 05:45 AM, Stanimir Varbanov wrote:
>> Document DT bindings used to describe the Qualcomm SPMI PMICs.
>> Currently the SPMI PMICs supported are pm8941, pm8841 and pma8084.
>>
>> Signed-off-by: Stanimir Varbanov <svarbanov@xxxxxxxxxx>
>
> (...)
>> +Required properties for peripheral child nodes:
>> +- compatible: Should contain "qcom,pm8xxx-xxx", where "xxx" is
>> + peripheral name. The "pm8xxx" can be any of supported PMICs,
>> + see example below.
>
> I don't think that this binding document should be imposing any formatting
> restrictions on the compatible strings for QPNP peripheral drivers. The
> QPNP peripheral drivers in the downstream msm-3.10 tree [1] do not specify
> per-PMIC compatible strings. This is because ideally, a given QPNP
> peripheral represents a hardware block that is identical in interface and
> operation between PMICs.
>
Isn't "hardware block that is identical in interface and operation
between PMICs" exactly the meaning of *compatible* property?
No *compatible* property, no platform device. We must have this property
for every peripheral driver.
> These peripheral drivers determine the base address for a given device
> instance via device tree reg and reg-names properties. In order for this
> to continue to work with the pm8xxx-spmi driver, some mechanism will need
> to be introduced which creates resource structs for the
> non-memory-mappable SPMI base addresses. One possible solution is
> currently being discussed in another thread [2]. This document will need
> to be updated to show the child node reg property scheme once a solution
> is reached.
>
That's correct. If we reach the "reg" solution this binding document
must be changed.
> (...)
>> +Example:
>> +
>> + pm8941@0 {
>> + compatible = "qcom,pm8941";
>> + reg = <0x0 SPMI_USID>;
>> +
>> + rtc {
>> + compatible = "qcom,pm8941-rtc";
>> + interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
>> + interrupt-names = "alarm";
>> + };
>> + };
>
> Can you please expand your example to include the second SID for the
> PM8941 chip? That way, it will be clear that each PMIC needs two DT
> nodes; one for each SID.
Sure, will do.
--
regards,
Stan
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
