This is an automatic generated email to let you know that the following patch were queued at the http://git.linuxtv.org/media_tree.git tree: Subject: [media] media: atmel-isi: add primary DT support Author: Josh Wu <josh.wu@xxxxxxxxx> Date: Mon Jul 28 04:25:17 2014 -0300 This patch add the DT support for Atmel ISI driver. It use the same v4l2 DT interface that defined in video-interfaces.txt. Signed-off-by: Josh Wu <josh.wu@xxxxxxxxx> Cc: devicetree@xxxxxxxxxxxxxxx Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> Signed-off-by: Guennadi Liakhovetski <g.liakhovetski@xxxxxx> Signed-off-by: Mauro Carvalho Chehab <m.chehab@xxxxxxxxxxx> .../devicetree/bindings/media/atmel-isi.txt | 51 +++++++++++++++ drivers/media/platform/soc_camera/atmel-isi.c | 65 +++++++++++++++++++- 2 files changed, 114 insertions(+), 2 deletions(-) --- http://git.linuxtv.org/media_tree.git?a=commitdiff;h=8ff19bc437f8d42d8a03dafe2bb28c5b3fc1bff1 diff --git a/Documentation/devicetree/bindings/media/atmel-isi.txt b/Documentation/devicetree/bindings/media/atmel-isi.txt new file mode 100644 index 0000000..17e71b7 --- /dev/null +++ b/Documentation/devicetree/bindings/media/atmel-isi.txt @@ -0,0 +1,51 @@ +Atmel Image Sensor Interface (ISI) SoC Camera Subsystem +---------------------------------------------- + +Required properties: +- compatible: must be "atmel,at91sam9g45-isi" +- reg: physical base address and length of the registers set for the device; +- interrupts: should contain IRQ line for the ISI; +- clocks: list of clock specifiers, corresponding to entries in + the clock-names property; +- clock-names: must contain "isi_clk", which is the isi peripherial clock. + +ISI supports a single port node with parallel bus. It should contain one +'port' child node with child 'endpoint' node. Please refer to the bindings +defined in Documentation/devicetree/bindings/media/video-interfaces.txt. + +Example: + isi: isi@f0034000 { + compatible = "atmel,at91sam9g45-isi"; + reg = <0xf0034000 0x4000>; + interrupts = <37 IRQ_TYPE_LEVEL_HIGH 5>; + + clocks = <&isi_clk>; + clock-names = "isi_clk"; + + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_isi>; + + port { + #address-cells = <1>; + #size-cells = <0>; + + isi_0: endpoint { + remote-endpoint = <&ov2640_0>; + bus-width = <8>; + }; + }; + }; + + i2c1: i2c@f0018000 { + ov2640: camera@0x30 { + compatible = "omnivision,ov2640"; + reg = <0x30>; + + port { + ov2640_0: endpoint { + remote-endpoint = <&isi_0>; + bus-width = <8>; + }; + }; + }; + }; diff --git a/drivers/media/platform/soc_camera/atmel-isi.c b/drivers/media/platform/soc_camera/atmel-isi.c index d32c533..3408b04 100644 --- a/drivers/media/platform/soc_camera/atmel-isi.c +++ b/drivers/media/platform/soc_camera/atmel-isi.c @@ -25,6 +25,7 @@ #include <media/atmel-isi.h> #include <media/soc_camera.h> #include <media/soc_mediabus.h> +#include <media/v4l2-of.h> #include <media/videobuf2-dma-contig.h> #define MAX_BUFFER_NUM 32 @@ -33,6 +34,7 @@ #define VID_LIMIT_BYTES (16 * 1024 * 1024) #define MIN_FRAME_RATE 15 #define FRAME_INTERVAL_MILLI_SEC (1000 / MIN_FRAME_RATE) +#define ISI_DEFAULT_MCLK_FREQ 25000000 /* Frame buffer descriptor */ struct fbd { @@ -876,6 +878,51 @@ static int atmel_isi_remove(struct platform_device *pdev) return 0; } +static int atmel_isi_probe_dt(struct atmel_isi *isi, + struct platform_device *pdev) +{ + struct device_node *np= pdev->dev.of_node; + struct v4l2_of_endpoint ep; + int err; + + /* Default settings for ISI */ + isi->pdata.full_mode = 1; + isi->pdata.mck_hz = ISI_DEFAULT_MCLK_FREQ; + isi->pdata.frate = ISI_CFG1_FRATE_CAPTURE_ALL; + + np = of_graph_get_next_endpoint(np, NULL); + if (!np) { + dev_err(&pdev->dev, "Could not find the endpoint\n"); + return -EINVAL; + } + + err = v4l2_of_parse_endpoint(np, &ep); + if (err) { + dev_err(&pdev->dev, "Could not parse the endpoint\n"); + goto err_probe_dt; + } + + switch (ep.bus.parallel.bus_width) { + case 8: + isi->pdata.data_width_flags = ISI_DATAWIDTH_8; + break; + case 10: + isi->pdata.data_width_flags = + ISI_DATAWIDTH_8 | ISI_DATAWIDTH_10; + break; + default: + dev_err(&pdev->dev, "Unsupported bus width: %d\n", + ep.bus.parallel.bus_width); + err = -EINVAL; + goto err_probe_dt; + } + +err_probe_dt: + of_node_put(np); + + return err; +} + static int atmel_isi_probe(struct platform_device *pdev) { unsigned int irq; @@ -887,7 +934,7 @@ static int atmel_isi_probe(struct platform_device *pdev) struct isi_platform_data *pdata; pdata = dev->platform_data; - if (!pdata || !pdata->data_width_flags) { + if ((!pdata || !pdata->data_width_flags) && !pdev->dev.of_node) { dev_err(&pdev->dev, "No config available for Atmel ISI\n"); return -EINVAL; @@ -903,7 +950,14 @@ static int atmel_isi_probe(struct platform_device *pdev) if (IS_ERR(isi->pclk)) return PTR_ERR(isi->pclk); - memcpy(&isi->pdata, pdata, sizeof(isi->pdata)); + if (pdata) { + memcpy(&isi->pdata, pdata, sizeof(isi->pdata)); + } else { + ret = atmel_isi_probe_dt(isi, pdev); + if (ret) + return ret; + } + isi->active = NULL; spin_lock_init(&isi->lock); INIT_LIST_HEAD(&isi->video_buffer_list); @@ -1005,11 +1059,18 @@ err_alloc_ctx: return ret; } +static const struct of_device_id atmel_isi_of_match[] = { + { .compatible = "atmel,at91sam9g45-isi" }, + { } +}; +MODULE_DEVICE_TABLE(of, atmel_isi_of_match); + static struct platform_driver atmel_isi_driver = { .remove = atmel_isi_remove, .driver = { .name = "atmel_isi", .owner = THIS_MODULE, + .of_match_table = of_match_ptr(atmel_isi_of_match), }, }; -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
