There is no phy driver that works on the Rockchip board for either USB host port yet. For now just hardcode the vbus signal to be on all the time which makes both the dwc2 host and the EHCI port work. Signed-off-by: Doug Anderson <dianders@xxxxxxxxxxxx> --- Changes in v2: - usb_host_vbus => vcc_host to match supply name, not pin name. - pin name now matches in name in schematic arch/arm/boot/dts/rk3288-evb.dtsi | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+) diff --git a/arch/arm/boot/dts/rk3288-evb.dtsi b/arch/arm/boot/dts/rk3288-evb.dtsi index 749e20d..e6c5b03 100644 --- a/arch/arm/boot/dts/rk3288-evb.dtsi +++ b/arch/arm/boot/dts/rk3288-evb.dtsi @@ -35,6 +35,18 @@ debounce-interval = <100>; }; }; + + /* This turns on USB vbus for both host0 (ehci) and host1 (dwc2) */ + vcc_host: vcc-host-regulator { + compatible = "regulator-fixed"; + enable-active-high; + gpio = <&gpio0 14 GPIO_ACTIVE_HIGH>; + pinctrl-names = "default"; + pinctrl-0 = <&host_vbus_drv>; + regulator-name = "vcc_host"; + regulator-always-on; + regulator-boot-on; + }; }; &i2c0 { @@ -71,4 +83,10 @@ rockchip,pins = <0 5 RK_FUNC_GPIO &pcfg_pull_up>; }; }; + + usb { + host_vbus_drv: host-vbus-drv { + rockchip,pins = <0 14 RK_FUNC_GPIO &pcfg_pull_none>; + }; + }; }; -- 2.0.0.526.g5318336 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html