Instead of storing the GPIO state in the mfd (where it isn't used) store it in the regulator. Signed-off-by: Alistair Francis <alistair@xxxxxxxxxxxxx> --- drivers/regulator/sy7636a-regulator.c | 21 ++++++++++++++++----- 1 file changed, 16 insertions(+), 5 deletions(-) diff --git a/drivers/regulator/sy7636a-regulator.c b/drivers/regulator/sy7636a-regulator.c index 0bd21c3ea24a..37bf2a3c06b7 100644 --- a/drivers/regulator/sy7636a-regulator.c +++ b/drivers/regulator/sy7636a-regulator.c @@ -13,6 +13,11 @@ #include <linux/gpio/consumer.h> #include <linux/mfd/sy7636a.h> +struct sy7636a_data { + struct sy7636a *sy7636a; + struct gpio_desc *pgood_gpio; +}; + static int sy7636a_get_vcom_voltage_op(struct regulator_dev *rdev) { int ret; @@ -33,10 +38,10 @@ static int sy7636a_get_vcom_voltage_op(struct regulator_dev *rdev) static int sy7636a_get_status(struct regulator_dev *rdev) { - struct sy7636a *sy7636a = dev_get_drvdata(rdev->dev.parent); + struct sy7636a_data *data = dev_get_drvdata(rdev->dev.parent); int ret = 0; - ret = gpiod_get_value_cansleep(sy7636a->pgood_gpio); + ret = gpiod_get_value_cansleep(data->pgood_gpio); if (ret < 0) dev_err(&rdev->dev, "Failed to read pgood gpio: %d\n", ret); @@ -69,20 +74,26 @@ static int sy7636a_regulator_probe(struct platform_device *pdev) struct regulator_config config = { }; struct regulator_dev *rdev; struct gpio_desc *gdp; + struct sy7636a_data *data; int ret; if (!sy7636a) return -EPROBE_DEFER; - platform_set_drvdata(pdev, sy7636a); - gdp = devm_gpiod_get(pdev->dev.parent, "epd-pwr-good", GPIOD_IN); if (IS_ERR(gdp)) { dev_err(pdev->dev.parent, "Power good GPIO fault %ld\n", PTR_ERR(gdp)); return PTR_ERR(gdp); } - sy7636a->pgood_gpio = gdp; + data = devm_kzalloc(&pdev->dev, sizeof(struct sy7636a_data), GFP_KERNEL); + if (!data) + return -ENOMEM; + + data->sy7636a = sy7636a; + data->pgood_gpio = gdp; + + platform_set_drvdata(pdev, data); ret = regmap_write(sy7636a->regmap, SY7636A_REG_POWER_ON_DELAY_TIME, 0x0); if (ret) { -- 2.31.1