Hi Nathan, On Thu, Jul 01, 2021 at 12:52:20AM -0700, Nathan Chancellor wrote: > On 7/1/2021 12:40 AM, Will Deacon wrote: > > On Wed, Jun 30, 2021 at 08:56:51AM -0700, Nathan Chancellor wrote: > > > On Wed, Jun 30, 2021 at 12:43:48PM +0100, Will Deacon wrote: > > > > On Wed, Jun 30, 2021 at 05:17:27PM +0800, Claire Chang wrote: > > > > > `BUG: unable to handle page fault for address: 00000000003a8290` and > > > > > the fact it crashed at `_raw_spin_lock_irqsave` look like the memory > > > > > (maybe dev->dma_io_tlb_mem) was corrupted? > > > > > The dev->dma_io_tlb_mem should be set here > > > > > (https://git.kernel.org/pub/scm/linux/kernel/git/next/linux-next.git/tree/drivers/pci/probe.c#n2528) > > > > > through device_initialize. > > > > > > > > I'm less sure about this. 'dma_io_tlb_mem' should be pointing at > > > > 'io_tlb_default_mem', which is a page-aligned allocation from memblock. > > > > The spinlock is at offset 0x24 in that structure, and looking at the > > > > register dump from the crash: > > > > > > > > Jun 29 18:28:42 hp-4300G kernel: RSP: 0018:ffffadb4013db9e8 EFLAGS: 00010006 > > > > Jun 29 18:28:42 hp-4300G kernel: RAX: 00000000003a8290 RBX: 0000000000000000 RCX: ffff8900572ad580 > > > > Jun 29 18:28:42 hp-4300G kernel: RDX: ffff89005653f024 RSI: 00000000000c0000 RDI: 0000000000001d17 > > > > Jun 29 18:28:42 hp-4300G kernel: RBP: 000000000a20d000 R08: 00000000000c0000 R09: 0000000000000000 > > > > Jun 29 18:28:42 hp-4300G kernel: R10: 000000000a20d000 R11: ffff89005653f000 R12: 0000000000000212 > > > > Jun 29 18:28:42 hp-4300G kernel: R13: 0000000000001000 R14: 0000000000000002 R15: 0000000000200000 > > > > Jun 29 18:28:42 hp-4300G kernel: FS: 00007f1f8898ea40(0000) GS:ffff890057280000(0000) knlGS:0000000000000000 > > > > Jun 29 18:28:42 hp-4300G kernel: CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 > > > > Jun 29 18:28:42 hp-4300G kernel: CR2: 00000000003a8290 CR3: 00000001020d0000 CR4: 0000000000350ee0 > > > > Jun 29 18:28:42 hp-4300G kernel: Call Trace: > > > > Jun 29 18:28:42 hp-4300G kernel: _raw_spin_lock_irqsave+0x39/0x50 > > > > Jun 29 18:28:42 hp-4300G kernel: swiotlb_tbl_map_single+0x12b/0x4c0 > > > > > > > > Then that correlates with R11 holding the 'dma_io_tlb_mem' pointer and > > > > RDX pointing at the spinlock. Yet RAX is holding junk :/ > > > > > > > > I agree that enabling KASAN would be a good idea, but I also think we > > > > probably need to get some more information out of swiotlb_tbl_map_single() > > > > to see see what exactly is going wrong in there. > > > > > > I can certainly enable KASAN and if there is any debug print I can add > > > or dump anything, let me know! > > > > I bit the bullet and took v5.13 with swiotlb/for-linus-5.14 merged in, built > > x86 defconfig and ran it on my laptop. However, it seems to work fine! > > > > Please can you share your .config? > > Sure thing, it is attached. It is just Arch Linux's config run through > olddefconfig. The original is below in case you need to diff it. > > https://raw.githubusercontent.com/archlinux/svntogit-packages/9045405dc835527164f3034b3ceb9a67c7a53cd4/trunk/config > > If there is anything more that I can provide, please let me know. I eventually got this booting (for some reason it was causing LD to SEGV trying to link it for a while...) and sadly it works fine on my laptop. Hmm. Did you manage to try again with KASAN? It might also be worth taking the IOMMU out of the equation, since that interfaces differently with SWIOTLB and I couldn't figure out the code path from the log you provided. What happens if you boot with "amd_iommu=off swiotlb=force"? (although word of warning here: i915 dies horribly on my laptop if I pass swiotlb=force, even with the distro 5.10 kernel) Will
