1. SVS driver uses OPP adjust event in [1] to update OPP table voltage part. 2. SVS driver gets thermal/GPU device by node [2][3] and CPU device by get_cpu_device(). After retrieving subsys device, SVS driver calls device_link_add() to make sure probe/suspend callback priority. 3. SVS dts refers to reset controller [4] to help reset SVS HW. #mt8183 SVS related patches [1] https://patchwork.kernel.org/patch/11193513/ [2] https://patchwork.kernel.org/project/linux-mediatek/patch/20201013102358.22588-2-michael.kao@xxxxxxxxxxxx/ [3] https://patchwork.kernel.org/project/linux-mediatek/patch/20200306041345.259332-3-drinkcat@xxxxxxxxxxxx/ #mt8192 SVS related patches [1] https://patchwork.kernel.org/patch/11193513/ [2] https://patchwork.kernel.org/project/linux-mediatek/patch/20201223074944.2061-1-michael.kao@xxxxxxxxxxxx/ [3] https://lore.kernel.org/patchwork/patch/1360551/ [4] https://patchwork.kernel.org/project/linux-mediatek/patch/20200817030324.5690-5-crystal.guo@xxxxxxxxxxxx/ changes since v18: - Add edge case handling in svs_set_freqs_pct_v3() when turn_pt is 0. If we don't add this handling, SVS HIGH bank will fill FREQPCT74 / FREQPCT30 with 0 and SVS controller won't run normally. - Remove redundant SVSB_MON_VOLT_IGNORE flag from svs_mt8192_banks[]'s low bank configuration. Roger Lu (7): [v19,1/7] dt-bindings: soc: mediatek: add mtk svs dt-bindings [v19,2/7] arm64: dts: mt8183: add svs device information [v19,3/7] soc: mediatek: SVS: introduce MTK SVS engine [v19,4/7] soc: mediatek: SVS: add debug commands [v19,5/7] dt-bindings: soc: mediatek: add mt8192 svs dt-bindings [v19,6/7] arm64: dts: mt8192: add svs device information [v19,7/7] soc: mediatek: SVS: add mt8192 SVS GPU driver .../bindings/soc/mediatek/mtk-svs.yaml | 92 + arch/arm64/boot/dts/mediatek/mt8183.dtsi | 15 + arch/arm64/boot/dts/mediatek/mt8192.dtsi | 34 + drivers/soc/mediatek/Kconfig | 10 + drivers/soc/mediatek/Makefile | 1 + drivers/soc/mediatek/mtk-svs.c | 2527 +++++++++++++++++ 6 files changed, 2679 insertions(+) create mode 100644 Documentation/devicetree/bindings/soc/mediatek/mtk-svs.yaml create mode 100644 drivers/soc/mediatek/mtk-svs.c
