On Wed, 23 Jul 2014, Peter Griffin wrote: > This patch documents the device tree documentation required for > the ST usb3 controller glue layer found in STiH407 devices. > > Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@xxxxxx> > Signed-off-by: Peter Griffin <peter.griffin@xxxxxxxxxx> > --- > Documentation/devicetree/bindings/usb/dwc3-st.txt | 69 +++++++++++++++++++++++ > 1 file changed, 69 insertions(+) > create mode 100644 Documentation/devicetree/bindings/usb/dwc3-st.txt > > diff --git a/Documentation/devicetree/bindings/usb/dwc3-st.txt b/Documentation/devicetree/bindings/usb/dwc3-st.txt > new file mode 100644 > index 0000000..de3fea3 > --- /dev/null > +++ b/Documentation/devicetree/bindings/usb/dwc3-st.txt > @@ -0,0 +1,69 @@ > +ST DWC3 glue logic > + > +This file documents the parameters for the dwc3-st driver. > +This driver controls the glue logic used to configure the dwc3 core on > +STiH407 based platforms. > + > +Required properties: > + - compatible : must be "st,stih407-dwc3" Does this only exist for Cannes? > + - reg : glue logic base address and USB syscfg ctrl register offset > + - reg-names : should be "reg-glue" and "syscfg-reg" > + - st,syscon : should be phandle to system configuration node which > + encompasses the glue registers This should be st,syscfg. As you have it in the example. Besides this small issue, I don't see anything controversial so once fixed up, you can apply my: Acked-by: Lee Jones <lee.jones@xxxxxxxxxx> -- Lee Jones Linaro STMicroelectronics Landing Team Lead Linaro.org │ Open source software for ARM SoCs Follow Linaro: Facebook | Twitter | Blog -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html