On Fri, Jun 11, 2021 at 12:11:33PM +0300, Cristian Ciocaltea wrote: > Add pinctrl configuration for enabling the Ethernet MAC on RoseapplePi > SBC. Additionally, provide the necessary properties for the generic S500 > ethernet node in order to setup PHY and MDIO. > > Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@xxxxxxxxx> Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> Thanks, Mani > --- > arch/arm/boot/dts/owl-s500-roseapplepi.dts | 45 ++++++++++++++++++++++ > 1 file changed, 45 insertions(+) > > diff --git a/arch/arm/boot/dts/owl-s500-roseapplepi.dts b/arch/arm/boot/dts/owl-s500-roseapplepi.dts > index b8c5db2344aa..eb555f385283 100644 > --- a/arch/arm/boot/dts/owl-s500-roseapplepi.dts > +++ b/arch/arm/boot/dts/owl-s500-roseapplepi.dts > @@ -225,6 +225,27 @@ bias1-pinconf { > bias-pull-down; > }; > }; > + > + ethernet_pins: ethernet-pins { > + eth_rmii-pinmux { > + groups = "rmii_txd0_mfp", "rmii_txd1_mfp", > + "rmii_rxd0_mfp", "rmii_rxd1_mfp", > + "rmii_txen_mfp", "rmii_rxen_mfp", > + "rmii_crs_dv_mfp", "rmii_ref_clk_mfp"; > + function = "eth_rmii"; > + }; > + > + phy_clk-pinmux { > + groups = "clko_25m_mfp"; > + function = "clko_25m"; > + }; > + > + ref_clk-pinconf { > + groups = "rmii_ref_clk_drv"; > + drive-strength = <2>; > + }; > + > + }; > }; > > /* uSD */ > @@ -241,6 +262,30 @@ &mmc0 { > vqmmc-supply = <&sd_vcc>; > }; > > +ðernet { > + pinctrl-names = "default"; > + pinctrl-0 = <ðernet_pins>; > + phy-mode = "rmii"; > + phy-handle = <ð_phy>; > + status = "okay"; > + > + mdio { > + #address-cells = <1>; > + #size-cells = <0>; > + > + reset-gpios = <&pinctrl 88 GPIO_ACTIVE_LOW>; /* GPIOC24 */ > + reset-delay-us = <10000>; > + reset-post-delay-us = <150000>; > + > + eth_phy: ethernet-phy@3 { > + reg = <0x3>; > + max-speed = <100>; > + interrupt-parent = <&sirq>; > + interrupts = <0 IRQ_TYPE_LEVEL_LOW>; > + }; > + }; > +}; > + > &twd_timer { > status = "okay"; > }; > -- > 2.32.0 >