v2 changes: - Add new helpers to the regulator framework to obtain the voltage register address etc., as suggested by Mark. Added in patches 1 & 2. They get used in patch 5. - Use cpufreq-cpu0 in the cpufreq driver - Fixed one bug in patch 8, where deferred probing would attempt to fill the OPP table multiple times and cause a bunch of warnings Original cover letter: This series implements the DFLL/CL-DVFS clock source for the fast CPU cluster on Tegra124, and a cpufreq driver that uses the DFLL for clocking the CPU. Most of this is based on Paul Walmsley's public patch set from December 2013, which is available at http://comments.gmane.org/gmane.linux.ports.tegra/15273 The DFLL clock hardware is a voltage-controlled oscillator plus control logic that compares the generated output clock with a 51 MHz reference clock, and can make decisions to either lower or raise the DFLL voltage to keep the output rate close to the software-requested rate. The voltage changes are done by communicating with an off-chip PMIC via either I2C or PWM. As the DFLL oscillator is powered via the CPU rail, using the DFLL as the CPU clocksource also gives us dynamic CPU voltage scaling. This series has been tested on the Jetson TK1 (Rev C). Porting this to the Venice2 should be simple, though do note that it does not have active cooling. Thanks, Tuomas Paul Walmsley (1): clk: tegra: Add DFLL DVCO reset control for Tegra124 Tuomas Tynkkynen (15): regmap: Add regmap_get_device regulator: Add helpers for low-level register access clk: tegra: Add binding for the Tegra124 DFLL clocksource clk: tegra: Add library for the DFLL clock source (open-loop mode) clk: tegra: Add closed loop support for the DFLL clk: tegra: Add functions for parsing CVB tables clk: tegra: Add Tegra124 DFLL clocksource platform driver clk: tegra: Save/restore CCLKG_BURST_POLICY on suspend clk: tegra: Add the DFLL as a possible parent of the cclk_g clock ARM: tegra: Add the DFLL to Tegra124 device tree ARM: tegra: Enable the DFLL on the Jetson TK1 cpufreq: tegra124: Add device tree bindings cpufreq: Add cpufreq driver for Tegra124 ARM: tegra: Add entries for cpufreq on Tegra124 ARM: tegra: Update defconfig for tegra124-cpufreq .../bindings/clock/nvidia,tegra124-dfll.txt | 69 + .../bindings/cpufreq/tegra124-cpufreq.txt | 42 + Documentation/power/regulator/consumer.txt | 35 + arch/arm/boot/dts/tegra124-jetson-tk1.dts | 8 +- arch/arm/boot/dts/tegra124.dtsi | 31 + arch/arm/configs/tegra_defconfig | 1 + arch/arm/mach-tegra/Kconfig | 1 + drivers/base/regmap/regmap.c | 12 + drivers/clk/tegra/Makefile | 3 + drivers/clk/tegra/clk-dfll.c | 1735 ++++++++++++++++++++ drivers/clk/tegra/clk-dfll.h | 55 + drivers/clk/tegra/clk-tegra-super-gen4.c | 4 +- drivers/clk/tegra/clk-tegra124-dfll-fcpu.c | 165 ++ drivers/clk/tegra/clk-tegra124.c | 61 + drivers/clk/tegra/clk.h | 3 + drivers/clk/tegra/cvb.c | 133 ++ drivers/clk/tegra/cvb.h | 67 + drivers/cpufreq/Kconfig.arm | 1 + drivers/cpufreq/Makefile | 1 + drivers/cpufreq/tegra124-cpufreq.c | 169 ++ drivers/regulator/core.c | 71 + include/linux/regmap.h | 7 + include/linux/regulator/consumer.h | 26 + 23 files changed, 2698 insertions(+), 2 deletions(-) create mode 100644 Documentation/devicetree/bindings/clock/nvidia,tegra124-dfll.txt create mode 100644 Documentation/devicetree/bindings/cpufreq/tegra124-cpufreq.txt create mode 100644 drivers/clk/tegra/clk-dfll.c create mode 100644 drivers/clk/tegra/clk-dfll.h create mode 100644 drivers/clk/tegra/clk-tegra124-dfll-fcpu.c create mode 100644 drivers/clk/tegra/cvb.c create mode 100644 drivers/clk/tegra/cvb.h create mode 100644 drivers/cpufreq/tegra124-cpufreq.c -- 1.8.1.5 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html