On 5/19/21 5:41 AM, Andre Przywara wrote:
> The AXP305 PMIC used in AXP805 seems to be fully compatible to the
^^^^^^^^^^^^^^
Typo? Do you mean "used with the H616 SoC"?
> AXP805 PMIC, so add the proper chain of compatible strings.
>
> Also at least on one board (Orangepi Zero2) there is no interrupt line
> connected to the CPU, so make the "interrupts" property optional.
>
> Signed-off-by: Andre Przywara <andre.przywara@xxxxxxx>
> ---
> Documentation/devicetree/bindings/mfd/axp20x.txt | 3 ++-
> 1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/devicetree/bindings/mfd/axp20x.txt b/Documentation/devicetree/bindings/mfd/axp20x.txt
> index 4991a6415796..4fd748101e3c 100644
> --- a/Documentation/devicetree/bindings/mfd/axp20x.txt
> +++ b/Documentation/devicetree/bindings/mfd/axp20x.txt
> @@ -26,10 +26,10 @@ Required properties:
> * "x-powers,axp803"
> * "x-powers,axp806"
> * "x-powers,axp805", "x-powers,axp806"
> + * "x-powers,axp803", "x-powers,axp805", "x-powers,axp806"
^^^^^^
This should be x-powers,axp305.
Regards,
Samuel
> * "x-powers,axp809"
> * "x-powers,axp813"
> - reg: The I2C slave address or RSB hardware address for the AXP chip
> -- interrupts: SoC NMI / GPIO interrupt connected to the PMIC's IRQ pin
> - interrupt-controller: The PMIC has its own internal IRQs
> - #interrupt-cells: Should be set to 1
>
> @@ -43,6 +43,7 @@ more information:
> AXP20x/LDO3: software-based implementation
>
> Optional properties:
> +- interrupts: SoC NMI / GPIO interrupt connected to the PMIC's IRQ pin
> - x-powers,dcdc-freq: defines the work frequency of DC-DC in KHz
> AXP152/20X: range: 750-1875, Default: 1.5 MHz
> AXP22X/8XX: range: 1800-4050, Default: 3 MHz
>
