From: Lucas Stach <dev@xxxxxxxxxx>
HS400 requires a data strobe line in addition to the usual MMC signal
lines. If a board design neglects to wire up this signal, HS400 mode is
not available, even if both the controller and the eMMC are claiming to
support this mode. Add a DT flag to allow boards to disable the HS400
support in this case.
Signed-off-by: Lucas Stach <dev@xxxxxxxxxx>
Acked-by: Rob Herring <robh@xxxxxxxxxx>
---
Documentation/devicetree/bindings/mmc/mmc-controller.yaml | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/Documentation/devicetree/bindings/mmc/mmc-controller.yaml b/Documentation/devicetree/bindings/mmc/mmc-controller.yaml
index e141330c1114..ac80d09df3a9 100644
--- a/Documentation/devicetree/bindings/mmc/mmc-controller.yaml
+++ b/Documentation/devicetree/bindings/mmc/mmc-controller.yaml
@@ -220,6 +220,11 @@ properties:
description:
eMMC HS400 enhanced strobe mode is supported
+ no-mmc-hs400:
+ $ref: /schemas/types.yaml#/definitions/flag
+ description:
+ All eMMC HS400 modes are not supported.
+
dsr:
description:
Value the card Driver Stage Register (DSR) should be programmed
--
2.31.1
