Hi,
On Tue, May 4, 2021 at 6:17 AM Chen-Yu Tsai <wens@xxxxxxxxxx> wrote:
>
> From: Chen-Yu Tsai <wens@xxxxxxxx>
>
> The NanoPi K2 has a AP6212 WiFi+BT combo module. The WiFi portion is
> already enabled. The BT part is connected via UART and I2S.
>
> Enable the UART and add a device node describing the Bluetooth portion
> of the module.
>
> Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>
> ---
> Changes since v1:
> - added uart-has-rtscts property
> - added alias for uart_A
>
> Hi Neil, Martin,
>
> I dropped your review-bys since I added the UART alias and I'm not sure
> what the policy for those are.
>
> ChenYu
> ---
> .../boot/dts/amlogic/meson-gxbb-nanopi-k2.dts | 14 +++++++++++++-
> 1 file changed, 13 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-nanopi-k2.dts b/arch/arm64/boot/dts/amlogic/meson-gxbb-nanopi-k2.dts
> index 7273eed5292c..f017a263784f 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-nanopi-k2.dts
> +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-nanopi-k2.dts
> @@ -15,6 +15,7 @@ / {
>
> aliases {
> serial0 = &uart_AO;
> + serial1 = &uart_A;
this should not be needed anymore since
a26988e8fef4b258d1b771e0f4b2e3b67cb2e044 ("tty: serial: meson: if no
alias specified use an available id")
IIRC for "newly added" .dts we are only adding the alias for anything
that shows up in /dev/ for the user
meson-khadas-vim3.dtsi for example is not adding an alias for uart_A
(also used for Bluetooth)
Best regards,
Martin
