From: Vishwanatha Subbanna <vishwa@xxxxxxxxxxxxx>
These LEDs are directly connected to the BMC's GPIO bank.
Signed-off-by: Vishwanatha Subbanna <vishwa@xxxxxxxxxxxxx>
Signed-off-by: Eddie James <eajames@xxxxxxxxxxxxx>
Signed-off-by: Joel Stanley <joel@xxxxxxxxx>
---
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts | 24 ++++++++++++++++++--
1 file changed, 22 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts b/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
index e775ad026d8b..1515f81a6c9f 100644
--- a/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
+++ b/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
@@ -135,6 +135,26 @@ i2c2mux3: i2c@3 {
leds {
compatible = "gpio-leds";
+ /* BMC Card fault LED at the back */
+ bmc-ingraham0 {
+ gpios = <&gpio0 ASPEED_GPIO(H, 1) GPIO_ACTIVE_LOW>;
+ };
+
+ /* Enclosure ID LED at the back */
+ rear-enc-id0 {
+ gpios = <&gpio0 ASPEED_GPIO(H, 2) GPIO_ACTIVE_LOW>;
+ };
+
+ /* Enclosure fault LED at the back */
+ rear-enc-fault0 {
+ gpios = <&gpio0 ASPEED_GPIO(H, 3) GPIO_ACTIVE_LOW>;
+ };
+
+ /* PCIE slot power LED */
+ pcieslot-power {
+ gpios = <&gpio0 ASPEED_GPIO(P, 4) GPIO_ACTIVE_LOW>;
+ };
+
/* System ID LED that is at front on Op Panel */
front-sys-id0 {
retain-state-shutdown;
@@ -178,7 +198,7 @@ &gpio0 {
/*E0-E7*/ "","","","","","","","",
/*F0-F7*/ "","","","","","","","",
/*G0-G7*/ "","","","","","","","",
- /*H0-H7*/ "","","","","","","","",
+ /*H0-H7*/ "","bmc-ingraham0","rear-enc-id0","rear-enc-fault0","","","","",
/*I0-I7*/ "","","","","","","","",
/*J0-J7*/ "","","","","","","","",
/*K0-K7*/ "","","","","","","","",
@@ -186,7 +206,7 @@ &gpio0 {
/*M0-M7*/ "","","","","","","","",
/*N0-N7*/ "","","","","","","","",
/*O0-O7*/ "","","","usb-power","","","","",
- /*P0-P7*/ "","","","","","","","",
+ /*P0-P7*/ "","","","","pcieslot-power","","","",
/*Q0-Q7*/ "cfam-reset","","","","","","","",
/*R0-R7*/ "","","","","","","","",
/*S0-S7*/ "presence-ps0","presence-ps1","presence-ps2","presence-ps3",
--
2.27.0
