On Fri, Mar 12, 2021 at 01:52:13PM -0600, Robert Hancock wrote: > Update DT bindings to describe all of the clocks that the axienet > driver will now be able to make use of. > > Signed-off-by: Robert Hancock <robert.hancock@xxxxxxxxxx> > --- > .../bindings/net/xilinx_axienet.txt | 25 ++++++++++++++----- > 1 file changed, 19 insertions(+), 6 deletions(-) > > diff --git a/Documentation/devicetree/bindings/net/xilinx_axienet.txt b/Documentation/devicetree/bindings/net/xilinx_axienet.txt > index 2cd452419ed0..b8e4894bc634 100644 > --- a/Documentation/devicetree/bindings/net/xilinx_axienet.txt > +++ b/Documentation/devicetree/bindings/net/xilinx_axienet.txt > @@ -42,11 +42,23 @@ Optional properties: > support both 1000BaseX and SGMII modes. If set, the phy-mode > should be set to match the mode selected on core reset (i.e. > by the basex_or_sgmii core input line). > -- clocks : AXI bus clock for the device. Refer to common clock bindings. > - Used to calculate MDIO clock divisor. If not specified, it is > - auto-detected from the CPU clock (but only on platforms where > - this is possible). New device trees should specify this - the > - auto detection is only for backward compatibility. > +- clock-names: Tuple listing input clock names. Possible clocks: > + s_axi_lite_clk: Clock for AXI register slave interface > + axis_clk: AXI4-Stream clock for TXD RXD TXC and RXS interfaces > + ref_clk: Ethernet reference clock, used by signal delay > + primitives and transceivers > + mgt_clk: MGT reference clock (used by optional internal > + PCS/PMA PHY) '_clk' is redundant. > + > + Note that if s_axi_lite_clk is not specified by name, the > + first clock of any name is used for this. If that is also not > + specified, the clock rate is auto-detected from the CPU clock > + (but only on platforms where this is possible). New device > + trees should specify all applicable clocks by name - the > + fallbacks to an unnamed clock or to CPU clock are only for > + backward compatibility. > +- clocks: Phandles to input clocks matching clock-names. Refer to common > + clock bindings. > - axistream-connected: Reference to another node which contains the resources > for the AXI DMA controller used by this device. > If this is specified, the DMA-related resources from that > @@ -62,7 +74,8 @@ Example: > device_type = "network"; > interrupt-parent = <µblaze_0_axi_intc>; > interrupts = <2 0 1>; > - clocks = <&axi_clk>; > + clock-names = "s_axi_lite_clk", "axis_clk", "ref_clk", "mgt_clk"; > + clocks = <&axi_clk>, <&axi_clk>, <&pl_enet_ref_clk>, <&mgt_clk>; > phy-mode = "mii"; > reg = <0x40c00000 0x40000 0x50c00000 0x40000>; > xlnx,rxcsum = <0x2>; > -- > 2.27.0 >
