STM32 F7/H7 usarts supports RX & TX pin swapping.
Add option to turn it on.
Tested on STM32MP157.
Signed-off-by: Martin Devera <devik@xxxxxxxxxx>
---
drivers/tty/serial/stm32-usart.c | 11 ++++++++++-
drivers/tty/serial/stm32-usart.h | 4 ++++
2 files changed, 14 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index b3675cf25a69..d390f7da1441 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -644,6 +644,12 @@ static int stm32_usart_startup(struct uart_port *port)
if (ret)
return ret;
+ if (stm32_port->swap) {
+ val = readl_relaxed(port->membase + ofs->cr2);
+ val |= USART_CR2_SWAP;
+ writel_relaxed(val, port->membase + ofs->cr2);
+ }
+
/* RX FIFO Flush */
if (ofs->rqr != UNDEF_REG)
stm32_usart_set_bits(port, ofs->rqr, USART_RQR_RXFRQ);
@@ -758,7 +764,7 @@ static void stm32_usart_set_termios(struct uart_port *port,
cr1 = USART_CR1_TE | USART_CR1_RE;
if (stm32_port->fifoen)
cr1 |= USART_CR1_FIFOEN;
- cr2 = 0;
+ cr2 = stm32_port->swap ? USART_CR2_SWAP : 0;
cr3 = readl_relaxed(port->membase + ofs->cr3);
cr3 &= USART_CR3_TXFTIE | USART_CR3_RXFTCFG_MASK | USART_CR3_RXFTIE
| USART_CR3_TXFTCFG_MASK;
@@ -1006,6 +1012,9 @@ static int stm32_usart_init_port(struct stm32_port *stm32port,
return stm32port->wakeirq ? : -ENODEV;
}
+ stm32port->swap = stm32port->info->cfg.has_swap &&
+ of_property_read_bool(pdev->dev.of_node, "rx-tx-swap");
+
stm32port->fifoen = stm32port->info->cfg.has_fifo;
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
diff --git a/drivers/tty/serial/stm32-usart.h b/drivers/tty/serial/stm32-usart.h
index cb4f327c46db..a85391e71e8e 100644
--- a/drivers/tty/serial/stm32-usart.h
+++ b/drivers/tty/serial/stm32-usart.h
@@ -25,6 +25,7 @@ struct stm32_usart_offsets {
struct stm32_usart_config {
u8 uart_enable_bit; /* USART_CR1_UE */
bool has_7bits_data;
+ bool has_swap;
bool has_wakeup;
bool has_fifo;
int fifosize;
@@ -76,6 +77,7 @@ struct stm32_usart_info stm32f7_info = {
.cfg = {
.uart_enable_bit = 0,
.has_7bits_data = true,
+ .has_swap = true,
.fifosize = 1,
}
};
@@ -97,6 +99,7 @@ struct stm32_usart_info stm32h7_info = {
.cfg = {
.uart_enable_bit = 0,
.has_7bits_data = true,
+ .has_swap = true,
.has_wakeup = true,
.has_fifo = true,
.fifosize = 16,
@@ -271,6 +274,7 @@ struct stm32_port {
int last_res;
bool tx_dma_busy; /* dma tx busy */
bool hw_flow_control;
+ bool swap; /* swap RX & TX pins */
bool fifoen;
int wakeirq;
int rdr_mask; /* receive data register mask */
--
2.11.0
