Re: [PATCH 02/13] arm64: dts: qcom: Move sc7180 MI2S config to board files and make pulldown

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi,

On Thu, Feb 25, 2021 at 2:55 PM Konrad Dybcio
<konrad.dybcio@xxxxxxxxxxxxxx> wrote:
>
> Hi,
>
>
> >
> > +&pri_mi2s_active {
> > +     pinconf {
> > +             pins = "gpio53", "gpio54", "gpio55", "gpio56";
> > +             drive-strength = <2>;
> > +             bias-pull-down;
> > +     };
> > +};
> > +
>
> You can omit pinconf{}, so the outcome would be:
> &pri_mi2s_active {
>
>     pins = ...
>
>     ...
>
> };
>
>
> This makes the DTs ever so shorter and is the style that's currently used for new submissions.
>
> Same goes for the nodes that are being referenced.

Yes, I agree.  That definitely makes sense going forward, but I think
it'll just add to the confusion to switch a dts for a given SoC
mid-stride.  ...or, if we do switch the style it should be done in a
separate (no-op) patch series.  This series is already giant enough...

-Doug



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux