On Mon, Jan 18, 2021 at 4:52 PM Johan Jonker <jbx6244@xxxxxxxxx> wrote: > > Recently introduced async probe on mmc devices can shuffle block IDs. > Pin them to fixed values to ease booting in environments where UUIDs are > not practical. Use newly introduced aliases for mmcblk devices from [1]. > The sort order is based on reg address. > > [1] https://patchwork.kernel.org/patch/11747669/ I just saw this in the pull request: > Signed-off-by: Johan Jonker <jbx6244@xxxxxxxxx> > --- > arch/arm/boot/dts/rv1108.dtsi | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/arch/arm/boot/dts/rv1108.dtsi b/arch/arm/boot/dts/rv1108.dtsi > index bec47e0be..a754851f4 100644 > --- a/arch/arm/boot/dts/rv1108.dtsi > +++ b/arch/arm/boot/dts/rv1108.dtsi > @@ -19,6 +19,9 @@ > i2c1 = &i2c1; > i2c2 = &i2c2; > i2c3 = &i2c3; > + mmc0 = &emmc; > + mmc1 = &sdio; > + mmc2 = &sdmmc; > serial0 = &uart0; > serial1 = &uart1; > serial2 = &uart2; Please don't put these aliases into a .dtsi file, as not every board will provide each instance. The entire point of the aliases is to have sane enumeration, so you should start at index 0 for the first one that is actually present and count up from there. I would suggest you move these aliases into the .dts files for the existing boards for the next cycle, and then make sure only the ones that are present have an alias. It might actually be a good idea to have a warning in dtc when there is an alias pointing to a status="disabled" device, but I suspect there would be a lot of fallout from that. Arnd