Hi, I am sending this series to reflect the latest drivers which have been merged to mainline kernel. I have boot it on zcu102-rev1.0 and also zcu104-rev1.0. That's why I have also added DT for this newer revision. The series is based on https://github.com/Xilinx/linux-xlnx/tree/zynqmp/dt. And mio-bank patch requires update in dt-binding which has been posted here https://lore.kernel.org/r/5fa17dfe4b42abefd84b4cbb7b8bcd4d31398f40.1606914986.git.michal.simek@xxxxxxxxxx Thanks, Michal Changes in v2: - Remove reset description for IPs from this patch. IPs will be enabled separately with DT binding update. - Change patch subject Michal Simek (12): arm64: dts: zynqmp: Fix u48 si5382 chip on zcu111 arm64: dts: zynqmp: Add DT description for si5328 for zcu102/zcu106 arm64: dts: zynqmp: Enable si5341 driver for zcu102/106/111 arm64: dts: zynqmp: Enable reset controller driver arm64: dts: zynqmp: Enable phy driver for Sata on zcu102/zcu104/zcu106 arm64: dts: zynqmp: Add label for zynqmp_ipi arm64: dts: zynqmp: Add missing mio-bank properties to sdhcis arm64: dts: zynqmp: Wire arasan nand controller arm64: dts: zynqmp: Wire zynqmp qspi controller arm64: dts: zynqmp: Add missing lpd watchdog node arm64: dts: zynqmp: Add missing iommu IDs arm64: dts: zynqmp: Add description for zcu104 revC arch/arm64/boot/dts/xilinx/Makefile | 1 + .../arm64/boot/dts/xilinx/zynqmp-clk-ccf.dtsi | 12 + .../boot/dts/xilinx/zynqmp-zcu100-revC.dts | 2 + .../boot/dts/xilinx/zynqmp-zcu102-revA.dts | 84 +++++- .../boot/dts/xilinx/zynqmp-zcu104-revA.dts | 29 ++ .../boot/dts/xilinx/zynqmp-zcu104-revC.dts | 282 ++++++++++++++++++ .../boot/dts/xilinx/zynqmp-zcu106-revA.dts | 78 +++++ .../boot/dts/xilinx/zynqmp-zcu111-revA.dts | 59 +++- arch/arm64/boot/dts/xilinx/zynqmp.dtsi | 94 +++++- 9 files changed, 637 insertions(+), 4 deletions(-) create mode 100644 arch/arm64/boot/dts/xilinx/zynqmp-zcu104-revC.dts -- 2.30.0
