From: Nicolas Ferre <nicolas.ferre@xxxxxxxxxxxxx>
Add the i2c gpio pinctrls to support the i2c bus recovery on this board.
Signed-off-by: Nicolas Ferre <nicolas.ferre@xxxxxxxxxxxxx>
Reviewed-by: Codrin Ciubotariu <codrin.ciubotariu@xxxxxxxxxxxxx>
---
arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi | 22 +++++++++++++++++++--
1 file changed, 20 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi b/arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi
index a06700e53e4c..025a78310e3a 100644
--- a/arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi
+++ b/arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi
@@ -43,14 +43,20 @@ uart6: serial@200 {
&i2c0 {
pinctrl-0 = <&pinctrl_i2c0_default>;
- pinctrl-names = "default";
+ pinctrl-1 = <&pinctrl_i2c0_gpio>;
+ pinctrl-names = "default", "gpio";
+ sda-gpios = <&pioA PIN_PD21 GPIO_ACTIVE_HIGH>;
+ scl-gpios = <&pioA PIN_PD22 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
status = "okay";
};
&i2c1 {
dmas = <0>, <0>;
- pinctrl-names = "default";
+ pinctrl-names = "default", "gpio";
pinctrl-0 = <&pinctrl_i2c1_default>;
+ pinctrl-1 = <&pinctrl_i2c1_gpio>;
+ sda-gpios = <&pioA PIN_PD19 GPIO_ACTIVE_HIGH>;
+ scl-gpios = <&pioA PIN_PD20 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
status = "okay";
mcp16502@5b {
@@ -258,12 +264,24 @@ pinctrl_i2c0_default: i2c0_default {
bias-disable;
};
+ pinctrl_i2c0_gpio: i2c0_gpio {
+ pinmux = <PIN_PD21__GPIO>,
+ <PIN_PD22__GPIO>;
+ bias-disable;
+ };
+
pinctrl_i2c1_default: i2c1_default {
pinmux = <PIN_PD19__TWD1>,
<PIN_PD20__TWCK1>;
bias-disable;
};
+ pinctrl_i2c1_gpio: i2c1_gpio {
+ pinmux = <PIN_PD19__GPIO>,
+ <PIN_PD20__GPIO>;
+ bias-disable;
+ };
+
pinctrl_macb0_default: macb0_default {
pinmux = <PIN_PB14__GTXCK>,
<PIN_PB15__GTXEN>,
--
2.30.0
