Hi Steen, On Wed, 2021-01-13 at 21:19 +0100, Steen Hegelund wrote: > Signed-off-by: Steen Hegelund <steen.hegelund@xxxxxxxxxxxxx> > --- > .../bindings/reset/microchip,rst.yaml | 52 +++++++++++++++++++ > 1 file changed, 52 insertions(+) > create mode 100644 Documentation/devicetree/bindings/reset/microchip,rst.yaml > > diff --git a/Documentation/devicetree/bindings/reset/microchip,rst.yaml b/Documentation/devicetree/bindings/reset/microchip,rst.yaml > new file mode 100644 > index 000000000000..b5526753e85d > --- /dev/null > +++ b/Documentation/devicetree/bindings/reset/microchip,rst.yaml > @@ -0,0 +1,52 @@ > +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) > +%YAML 1.2 > +--- > +$id: "http://devicetree.org/schemas/reset/microchip,rst.yaml#" > +$schema: "http://devicetree.org/meta-schemas/core.yaml#" > + > +title: Microchip Sparx5 Switch Reset Controller > + > +maintainers: > + - Steen Hegelund <steen.hegelund@xxxxxxxxxxxxx> > + - Lars Povlsen <lars.povlsen@xxxxxxxxxxxxx> > + > +description: | > + The Microchip Sparx5 Switch provides reset control and implements the following > + functions > + - One Time Switch Core Reset (Soft Reset) > + > +properties: > + $nodename: > + pattern: "^reset-controller@[0-9a-f]+$" > + > + compatible: > + const: microchip,sparx5-switch-reset > + > + reg: > + maxItems: 1 > + > + "#reset-cells": > + const: 1 > + > + syscons: > + $ref: "/schemas/types.yaml#/definitions/phandle-array" > + description: Array of syscons used to access reset registers > + minItems: 2 The order seems to be important in the driver, so this should specify which is the CPU syscon and which is the GCB syscon. I'm not sure if it would be better to have two separately named syscon properties with a single phandle each. regards Philipp