Hi, On Thu, Dec 31, 2020 at 03:29:46PM +0100, Paul Kocialkowski wrote: > The A83T supports MIPI CSI-2 with a composite controller, covering > both the protocol logic and the D-PHY implementation. This controller > seems to be found on the A83T only and probably was abandoned since. > > This implementation splits the protocol and D-PHY registers and > uses the PHY framework internally. The D-PHY is not registered as a > standalone PHY driver since it cannot be used with any other > controller. > > There are a few notable points about the controller: > - The initialisation sequence involes writing specific magic init > values that do not seem to make any particular sense given the > concerned register fields; > - Interrupts appear to be hitting regardless of the interrupt mask > registers, which can cause a serious flood when transmission errors > occur. > > Only 8-bit and 10-bit Bayer formats are currently supported. > While up to 4 internal channels to the CSI controller exist, only one > is currently supported by this implementation. > > This work is based on the first version of the driver submitted by > Kévin L'hôpital, which was adapted to mainline from the Allwinner BSP. > This version integrates MIPI CSI-2 support as a standalone V4L2 subdev > instead of merging it in the sun6i-csi driver. > > It was tested on a Banana Pi M3 board with an OV8865 sensor in a 4-lane > configuration. > > Signed-off-by: Paul Kocialkowski <paul.kocialkowski@xxxxxxxxxxx> There's a couple of checkpatch --strict warnings here as well Once fixed, Acked-by: Maxime Ripard <mripard@xxxxxxxxxx> Thanks! Maxime
Attachment:
signature.asc
Description: PGP signature
