Update the documentation and add the vendor prefix to the optional
properties referred in vendor-prefixes.yaml.
Follow up with
commit 8b5c2b45b8f0a ("phy: rockchip: set pulldown for strobe line in dts")
commit a8cef928276bb ("phy: rockchip-emmc: output tap delay dt property")
Signed-off-by: Chris Ruehl <chris.ruehl@xxxxxxxxxxxx>
---
.../devicetree/bindings/phy/rockchip-emmc-phy.txt | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/Documentation/devicetree/bindings/phy/rockchip-emmc-phy.txt b/Documentation/devicetree/bindings/phy/rockchip-emmc-phy.txt
index 00aa2d349e55..57d28c0d5696 100644
--- a/Documentation/devicetree/bindings/phy/rockchip-emmc-phy.txt
+++ b/Documentation/devicetree/bindings/phy/rockchip-emmc-phy.txt
@@ -16,11 +16,11 @@ Optional properties:
- drive-impedance-ohm: Specifies the drive impedance in Ohm.
Possible values are 33, 40, 50, 66 and 100.
If not set, the default value of 50 will be applied.
- - enable-strobe-pulldown: Enable internal pull-down for the strobe line.
- If not set, pull-down is not used.
- - output-tapdelay-select: Specifies the phyctrl_otapdlysec register.
- If not set, the register defaults to 0x4.
- Maximum value 0xf.
+ - rockchip,enable-strobe-pulldown: Enable internal pull-down for the strobe
+ line. If not set, pull-down is not used.
+ - rockchip,output-tapdelay-select: Specifies the phyctrl_otapdlysec register.
+ If not set, the register defaults to 0x4.
+ Maximum value 0xf.
Example:
--
2.20.1
