Hi Stefan,
On Tue, Dec 1, 2020 at 2:21 PM Stefan Agner <stefan@xxxxxxxx> wrote:
>
> According to the datasheet (Rev. 1.9) the RTL8211F requires at least
> 72ms "for internal circuits settling time" before accessing the PHY
> egisters. On similar boards with the same PHY this fixes an issue where
there's a typo here: it should be "registers"
this is the same for the other four patches also
> Ethernet link would not come up when using ip link set down/up.
I have never experienced that myself but gotten a few reports about this.
thank you very much for coming up with info from the datasheet!
the following stmmac patch [0] has been added recently which may - or
may not - have any impact also.
> Fixes: a2c6e82e5341 ("ARM: dts: meson: switch to the generic Ethernet PHY reset bindings")
> Signed-off-by: Stefan Agner <stefan@xxxxxxxx>
with above typo fixed:
Reviewed-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
and also:
Tested-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> #
on Odroid-C1+
Best regards,
Martin
[0] https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/commit/drivers/net/ethernet/stmicro/stmmac?id=56311a315da7ebc668dbcc2f1c99689cc10796c4
