On Tue, Dec 01, 2020 at 10:50:25PM +0900, Bongsu Jeon wrote:
> From: Bongsu Jeon <bongsu.jeon@xxxxxxxxxxx>
>
> Since S3FWRN82 NFC Chip, The UART interface can be used.
> S3FWRN82 supports I2C and UART interface.
>
> Signed-off-by: Bongsu Jeon <bongsu.jeon@xxxxxxxxxxx>
> ---
> .../bindings/net/nfc/samsung,s3fwrn5.yaml | 32 ++++++++++++++++++++--
> 1 file changed, 29 insertions(+), 3 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml b/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml
> index cb0b8a5..cc5f9a1 100644
> --- a/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml
> +++ b/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml
> @@ -12,7 +12,10 @@ maintainers:
>
> properties:
> compatible:
> - const: samsung,s3fwrn5-i2c
> + items:
This still has items but it should be a simple enum.
> + - enum:
> + - samsung,s3fwrn5-i2c
> + - samsung,s3fwrn82
>
> en-gpios:
> maxItems: 1
> @@ -47,10 +50,19 @@ additionalProperties: false
> required:
> - compatible
> - en-gpios
> - - interrupts
> - - reg
> - wake-gpios
>
> +allOf:
> + - if:
> + properties:
> + compatible:
> + contains:
> + const: samsung,s3fwrn5-i2c
> + then:
> + required:
> + - interrupts
> + - reg
> +
> examples:
> - |
> #include <dt-bindings/gpio/gpio.h>
> @@ -71,3 +83,17 @@ examples:
> wake-gpios = <&gpj0 2 GPIO_ACTIVE_HIGH>;
> };
> };
> + # UART example on Raspberry Pi
> + - |
> + uart0 {
> + status = "okay";
> +
> + nfc {
> + compatible = "samsung,s3fwrn82";
> +
> + en-gpios = <&gpio 20 0>;
> + wake-gpios = <&gpio 16 0>;
Use GPIO flags like in example above.
Best regards,
Krzysztof
