From: Frieder Schrempf <frieder.schrempf@xxxxxxxxxx>
There are other NXP NCI compatible NFC controllers such as the PN7150
that use an integrated firmware and therefore do not have a GPIO to
select firmware downloading mode. To support these kind of chips,
let's make the firmware GPIO optional.
Signed-off-by: Frieder Schrempf <frieder.schrempf@xxxxxxxxxx>
---
Changes in v2:
* Remove unneeded null check for phy->gpiod_fw
---
Documentation/devicetree/bindings/net/nfc/nxp-nci.txt | 2 +-
drivers/nfc/nxp-nci/i2c.c | 2 +-
2 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/nfc/nxp-nci.txt b/Documentation/devicetree/bindings/net/nfc/nxp-nci.txt
index cfaf88998918..cb2385c277d0 100644
--- a/Documentation/devicetree/bindings/net/nfc/nxp-nci.txt
+++ b/Documentation/devicetree/bindings/net/nfc/nxp-nci.txt
@@ -6,11 +6,11 @@ Required properties:
- reg: address on the bus
- interrupts: GPIO interrupt to which the chip is connected
- enable-gpios: Output GPIO pin used for enabling/disabling the chip
-- firmware-gpios: Output GPIO pin used to enter firmware download mode
Optional SoC Specific Properties:
- pinctrl-names: Contains only one value - "default".
- pintctrl-0: Specifies the pin control groups used for this controller.
+- firmware-gpios: Output GPIO pin used to enter firmware download mode
Example (for ARM-based BeagleBone with NPC100 NFC controller on I2C2):
diff --git a/drivers/nfc/nxp-nci/i2c.c b/drivers/nfc/nxp-nci/i2c.c
index 9f60e4dc5a90..7e451c10985d 100644
--- a/drivers/nfc/nxp-nci/i2c.c
+++ b/drivers/nfc/nxp-nci/i2c.c
@@ -286,7 +286,7 @@ static int nxp_nci_i2c_probe(struct i2c_client *client,
return PTR_ERR(phy->gpiod_en);
}
- phy->gpiod_fw = devm_gpiod_get(dev, "firmware", GPIOD_OUT_LOW);
+ phy->gpiod_fw = devm_gpiod_get_optional(dev, "firmware", GPIOD_OUT_LOW);
if (IS_ERR(phy->gpiod_fw)) {
nfc_err(dev, "Failed to get FW gpio\n");
return PTR_ERR(phy->gpiod_fw);
--
2.17.1
